User manual FESTOOL OFK 500 Q

[. . . ] Repairs and grinding work may only be carried out by Festool service centres or qualified experts. do not alter the construction of the tool. Clean tool regularly and remove all resin (use detergents with a pH value between 4. The specified illustrations can be found at the beginning of the operating instructions. [. . . ] Overall vibration levels (vector sum for three directions) measured in accordance with EN 60745: Vibration emission level (3-axis) ah < 2, 5 m/s2 Uncertainty K = 1, 5 m/s² The emission values specified (vibration, noise) were measured in accordance with the test conditions stipulated in EN 60745 and are intended for machine comparisons. They are also used for making preliminary estimates regarding vibration and noise loads during operation. The emission values specified refer to the main applications for which the power tool is used. If the electric power tool is used for other applications, with other tools or is not maintained sufficiently prior to operation, however, the vibration and noise load may be higher when the tool is used. Take into account any machine idling times and downtimes to estimate these values more accurately for a specified time period. This may significantly reduce the load during the machine operating period. 3 Power supply and start-up The line voltage and frequency must correspond with the data on the ratings plate!Always switch the machine off before connecting or disconnecting the mains lead!4 Machine settings Always remove the power supply plug from the socket before carrying out any work on the machine. 6) is locked using the sliding catch (1. 8): - Push sliding catch to front = lock setting ring gauge, - Push sliding catch to back = unlock setting ring gauge. Do not operate machine unless setting ring gauge is locked!2), until the locking button engages and therefore locks the spindle (2. The machine can be connected to a Festool extractor using the extraction adapter (1. 5 Working with the machine Always secure the workpiece in such a manner that it cannot move while being sawed. Set the required milling depth and steadily guide the machine along the edge of the workpiece, ensuring that the guiding table and the milling tool ball bearing are in contact with the workpiece at all times. 1 Install safety hood Attach safety hood (1. Maintenance and care Always remove the power supply plug from the socket before carrying out any work on the machine. always keep the machine and the ventilation slots clean. All maintenance and repair work which requires the motor casing to be opened may only be carried out by an authorised service centre. [. . . ] Keep the operating manual, safety instructions, spare parts list and purchase receipt in a safe place. Otherwise the respective, current warranty conditions of the manufacturer shall apply. Note Due to continuous research and development work, we reserve the right to make changes to the technical content of this documentation. REACH for Festool products, their accessories and consumables REACh is a European Chemical Directive that came into effect in 2007. [. . . ]