User manual FESTOOL RO 150 FE

[. . . ] Always wear protective goggles because of possible dangers when sanding. - The manufacturer's handling and processing instructions must be observed without fail if explosive or self-igniting dusts are likely to occur during sanding. - Prevent the penetration of liquid polish into the tool. The penetration of liquid polish into the power tool increases the risk of an electric shock. [. . . ] 6), - Turn the fitted sanding pad from the spindle (right-handed thread) - Keep the spindle stop pressed down and screw on the new sanding pad up to the stop (until it can be turned no more). Do not switch on the motor when the spindle stop is pressed in. 4 Attaching sanding material The appropriate Stickfix sanding paper and Stickfix sanding felt can be fastened quickly and easily onto the Stickfix sanding base. The self-adhesive sanding material is simply pressed onto the sanding base (1. Speed adjustment You can regulate the speed steplessly between 3300 and 6800 rpm using the adjusting wheel (1. This enables you to optimise the cutting speed to suit the material. Constant speed The pre-selected speed remains constant whether the machine is in operation or in neutral position. Temperature control If the motor temperature becomes too high, the power supply and speed are reduced. The tool then only runs with reduced power to enable rapid cooling by means of the motor ventilation. After cooling down, the tool accelerates again automatically. 5 Machine settings Always remove the power supply plug from the socket before carrying out any work on the machine. The change can only be made when the sanding pad is stationary, as the switch is locked in place during operation for reasons of safety. rotex rotary motion (coarse sanding , polishing) The Rotex rotary motion is a combination of rotary and eccentric motions. This position is selected for sanding with high output (coarse sanding) and polishing. After use, the StickFix sandpaper is simply pulled off. 5 Securing polishing attachments To prevent damage, PoliStick polishing attachments (sponges, felt, lambswool bonnets) may only be used on the special polishing pad that is fitted on the machine instead of a sanding pad. In the same way as the StickFix abrasives, the PoliStick polishing attachments are simply pressed onto the polishing pad and pulled off after use. Dust extraction Always connect the machine to a dust extractor when performing work that generates dust. You can connect a Festool extractor with an extractor hose diameter of 27 mm to the extractor connector (1. 2), draw the extraction adapter backwards and pull off. to reattach the extraction adapter , insert it as shown in Fig. 4 and slide it towards the sanding pad until the locking button (4. [. . . ] Damage caused by, in particular, natural wear, overloading, incorrect handling, or damage caused by the operator, or damage caused through use of the equipment contrary that specified in the Operating Instructions, or damage which was known at the time of purchase, is not covered by the warranty. Keep the Operating Instructions, Safety Instructions, Spare Parts List and purchase receipt in a safe place. Otherwise the respective, current warranty conditions of the manufacturer shall apply. Note Due to continuous research and development work, we reserve the right to make changes to the technical content of this documentation. [. . . ]