User manual FESTOOL T 15PLUS3

[. . . ] Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Save all warnings and instructions for future reference. The term "power tool" in the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. 2 Machine-related safety instructions ­ Hold power tool by insulated gripping surfaces, when performing an operation where the cutting accessory may contact hidden wiring or its own cord. [. . . ] LED green - flashing slowly Battery pack is charged with reduced current, LiIon is charged to 80 %. LED green - lit continuously Battery pack is fully charged, or charging is not started again, because the battery is charged to more than 80 %. Incomplete contact, short circuit, battery pack faulty, etc. 3 Charger wall mount The charger TRC 3 has two elongated holes on its back. It can be mounted on a wall using two screws (e. Round head or flat head screw with shank diameter of 5 mm) (see Fig. 3 Fastening Adjust the switch so that [1-8] its marking faces the screw [1-7] symbol. The torque can be adjusted in this position. l The switch-over function only works if the machine is switched off. X Adjust the torque accordingly at the torque [1-10] wheel: Position 1 = low torque Position 25 = high torque The machine switches off when the preset torque is reached and an acoustic signal sounds. The machine only continues running when the on/off switch is [1-3] released and then pressed again. 4 Drilling Adjust the switch [1-8] so that its marking faces the drilling symbol [1-6]. Risk of injury, electric shock X Always disconnect the battery pack before any type of work on the machine!1 Tool chuck CENTROTEC WH-CE [4] The tool chuck CENTROTEC WH-CE allows you to change tools with a CENTROTEC shank in a matter of seconds. Tool has sharp edges and can cause cutting injuries during a tool change. Otherwise there is a risk of damaging the gear unit. 4 Eccentric attachment DD-ES [7] The eccentric attachment (in part, additional equipment) permits screwdriving near edges with bits according to DIN 3126. 5 Tool holder in the drill spindle [8] Bits can be inserted directly in the hexagon socket holder on the drill spindle to shorten and reduce the weight of the machine. Observe the following instructions: ­ Keep the air slits on the machine and the charger free and clean to ensure adequate cooling. ⭠Keep the contacts on the machine , charger and battery pack clean. Information on battery packs ­ Where possible, store the battery pack in a cool, dry place at a temperature between 5 °C and 25 °C. ­ Battery packs are most efficient at temperatures between 20 °C and 30 °C. [. . . ] Note Due to continuous research and development work, we reserve the right to make changes to the technical content of this documentation. The equivalent amount of lithium in the LiIon battery pack is less than the applicable limit value and certified as per UN manual ST/SG/ AC. The LiIon battery pack is therefore not subject to national and international dangerous goods regulations, neither as an individual component nor as a fitted machine component. However, dangerous goods regulations may apply when several battery packs are transported, in which case you may have to fulfil special conditions. [. . . ]