User manual FESTOOL VB-CMS

[. . . ] REACH for Festool products, their accessories and consumables: REACh is a European Chemical Directive that came into effect in 2007. As "downstream users" and product manufacturers, we are aware of our duty to provide our customers with information. [. . . ] Removal Removal should proceed in reverse order to the fitting process. 1) until the saw table and the table widener are at the same height. 7) on both supporting arms - Turn both nuts (2. 6) until the saw table and the table widener form a level surface (Note: Check this by placing a straight rule across the saw table and table widener). Alignment of the V-groove Check after installation whether the pre-set profile setting rail can be pushed without any problems between saw table and table widener. If not: - Position the pre-set profile setting rail so that it makes equal contact with the saw table and the table widener. 7) on both supporting arms - Secure the angle stop in the specified position. For more secure support when sawing longer workpieces, a table lengthener can be fitted to extend the CS 50 EB/CMS GE saw table by 420 mm. - The table lengthener is fitted to the back of the table. When the sliding table is installed, the extension cannot be fitted. 2) of both rotary knobs into the slots (5. 3) on the retainers - Swivel the table widener downwards and insert the ends of the two supporting arms (6. [. . . ] 6) jusqu'à ce que la table de sciage et l'élargisseur de table forment une surface plane (Remarque :pour vérifier que la surface formée est bien plane, placez une règle à cheval sur la table de sciage et l'élargisseur de table). 2) jusqu'à ce que la table de sciage et la rallonge forment une surface plane (Remarque :pour vérifier que la surface formée est bien plane, placez une règle à cheval sur la table de sciage et la rallonge). [. . . ]