Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual FIELD CONTROLS 46477500. We hope that this FIELD CONTROLS 46477500 user guide will be useful to you.
Lastmanuals help download the user guide FIELD CONTROLS 46477500.
Manual abstract: user guide FIELD CONTROLS 46477500
Detailed instructions for use are in the User's Guide.
[. . . ] The tag MUST be attached to the draft inducer. Recording burner and draft inducer operation information (draft level, efficiency, etc) is recommended as a guide for future service.
2630 Airport Road · Kinston, NC 28504 Phone: 252-522-3031· Fax: 252-522-0214 www. fieldcontrols. com
I.
MOUNTING THE CONTROL BOX (Figure 1) 1. [. . . ] BE SURE TO ALIGN THE GROOVE IN THE PLUG WITH THE SPLINE IN THE SOCKET WHEN INSERTING!Connect the control box damper cable to the automatic damper. BE SURE TO ALIGN THE GROOVE IN THE PLUG WITH THE SPLINE IN THE SOCKET WHEN INSERTING!
Figure 3
IV.
INSTALL THE DI CONTROL KIT ADAPTER KIT ON THE DRAFT INDUCER (Pressure sensing port) 1. Refer to the included instructions with the kit for this procedure.
Page 2
V.
INSTALL THE DI-SERIES DRAFT INDUCER ON THE VENT PIPE (Figure 4) 1. Refer to the included DI instruction manual for this procedure. Set the draft adjustment plate on the draft inducer to maximum setting before installing NOTE: The draft inducer proving switch (DIP-1) is not required; a proving switch is provided on the control box. Connect the DI pressure sensing port as installed under step IV to the pressure switch mounted on the control box, using the supplied ¼" aluminum tubing and the supplied white plastic nut on the pressure switch port.
Pressure Sensing Port
VI.
CONNECT DRAFT INDUCER POWER CABLE TO CONTROL BOX (Figure 5) 1. Remove a knockout from the control box, and connect the conduit connector on the end of the draft inducer pre-wired power cable to the control box. Connect the green ground wire from the draft inducer to the stripped green ground wire riveted to the control box, using the supplied wire nut. Connect the black wire from the draft inducer to the "M" Plastic terminal on the control box. Connect the white wire from the draft inducer to the "N" terminal on the control box.
Figure 4
Adjusting Screw
VII.
CONNECT TO POWER SOURCE: 1. CAUTION: Disconnect power to the intended power source for the control box and draft inducer. [. . . ] Tighten the locknut on the adjusting screw. While the burner is firing, disconnect power to the control box. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE FIELD CONTROLS 46477500
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual FIELD CONTROLS 46477500 will begin.
