User manual FIESTA A24027 SPACEMAKER ASSEMBLY

[. . . ] Hazardous Fire or Explosion may result if these instructions are ignored. It is your responsibility to see that your new barbeque is assembled, installed, maintained and cared for properly. Failing to carefully follow the instructions in this manual could result in serious bodily injury and/or property damage. [. . . ] 2 Position remaining left front leg through console slot and insert leg cap. 3 Position console over right front leg through console slot. 4 Position left leg on bottom pan and loosely assemble with 1 1/2" bolt, washer and nut. 5 Loosely assemble left leg to console with casting Insert push button ignitor and snap into place. Carefully insert and snap ignitor electrode into ignitor clip as shown. Push into left hole with a twisting motion. Push clip assembly into lower centre groove of burner as shown. Carefully install burner through holes in bottom of casting. Ensure end of ignitor electrode and wire fit down through hole in casting, and electrode does not get damaged. Also ensure burner legs fit into casting slots and that venturi tube is centered over valve orifice by 10mm. Position cover and secure from rear with spring clip in groove on right hinge pin. Install front handle as shown using #10 x 3" bolts, plastic spacer, heat gasket and wing nuts. Attach shelf wood as shown using 1" Crosshead Screws. WARNING: Before proceeding with the following steps, ensure you have read: · Hose and Regulator Sections of the USE AND CARE INSTRUCTIONS located at the front of this manual. [. . . ] Refer to the checklist in the "Prior To Use" section of the USE AND CARE INSTRUCTIONS for the Leak Check and other safety checks which MUST BE PERFORMED before lighting your grill. Failure to follow those instructions may result in a hazardous fire or explosion causing serious bodily injury and/or property damage. How to Order Spare Parts: When ordering, always give the following information: 1. [. . . ]