User manual FIRENZI FDU700BK

[. . . ] ELECTRIC OVEN AND GRILL FDU 700 INSTRUCTION BOOKLET IMPORTANT SAFETY INFORMATION These warnings are provided in the interests of your safety. Ensure that you understand them all before installing or using the appliance. If you are unsure about any of the meanings of these warnings contact the Customer Care Department. INSTALLATION The appliance must be installed according to the instructions supplied. The installation work must be undertaken by a qualified electrician/competent person. [. . . ] cream filled gateaux, cakes covered with icings or frostings, cheesecakes, biscuits, scones, etc. HOW TO DEFROST · Turn the main oven temperature control to the defrost setting. THINGS TO NOTE · The oven fan and internal oven light will operate. HINTS AND TIPS · · · Place the frozen food in a single layer where possible and turn it over half way through the defrosting process. The actual speed of defrosting is influenced by room temperature. On warm days defrosting will be faster than on cooler days. It is preferable to thaw fish, meat and poultry slowly in the fridge. However, this process can be accelerated by using the defrost function. Small or thin fish fillets, frozen peeled prawns, cubed or minced meat, liver, thin chops, steaks etc. , can be thawed in 1 ­ 2 hours. A 1kg/2¼lb oven ready chicken will be thawed in approximately 5 hours. Remove the giblets as soon as possible during the thawing process. Joints of meat up to 2kg/4½lb in weight can be thawed using the defrost function. All joints of meat and poultry must be thawed thoroughly before cooking. thoroughly immediately after · · · · · · DO NOT leave food at room temperature once it is defrosted. Cook raw food immediately or store cooked food in the fridge, once it has cooled. Care must always be taken when handling foods in the home. Always follow the basic rules of food hygiene to prevent bacterial growth and cross contamination when defrosting, preparing, cooking cooling and freezing foods. 18 CARE AND CLEANING Before cleaning always allow the cooling fan to cool the appliance down before switching off at the electricity supply. CLEANING MATERIALS Before using any cleaning materials on your appliance, check that they are suitable and that their use is recommended by the manufacturer. Cleaners that contain bleach should NOT be used as they may dull the surface finishes. Harsh abrasives should also be avoided. CLEANING THE APPLIANCE OUTSIDE OF THE DO NOT use abrasive cleaning materials e. g. Hob Brite, Brillo pads or scourers on painted or printed finishes as damage may occur. Regularly wipe over the control panel, oven doors and appliance sides using a soft cloth and liquid detergent. To prevent streaking on stainless steel models (where applicable) finish with a soft cloth. Any spillage on the stainless steel finish must be wiped off immediately. Stainless Steel cream cleaners are abrasive and should be avoided as they may dull the surface finish. Do not attempt to remove any of the control knobs from the appliance as this may cause damage and is a safety hazard. Under no circumstances should the door assembly be detached from the product for cleaning. [. . . ] Cut bared wires 10mm away from the end of the inner insulation. Where uninsulated Earth wires are used ensure they are suitably sheathed to leave 10mm bare wire to fit into the terminal. Clamp bare wires into the relevant terminal and check they are held by tugging each one in turn. Clamp the mains cable securely ensuring 5mm of the outer insulation is inside the terminal block and that the wires are not taught but not so slack as to cause any fouling. [. . . ]