User manual FISHMAN AFX CHORUS ACOUSTIC EFFECTS PEDAL

[. . . ] The clip/batt LED may flash occasionally. Select an effect ­ Choose one of the eight modulation effects. Dial it in ­ Adjust the level, tone and speed to taste. [. . . ] Insert a plug into either input jack, and the pedal powers up. To conserve the battery, remove the plug(s) from the input jack(s) when not in use. For AC power, use the Fishman 910-R (for 110V) or other suitable 9V adapter. The adapter must be filtered, regulated and rated for at least 200mA. It must also accept AC power appropriate for your country. Power-plug requirements: 5. 5mm O. D. , 2mm I. D. , tip = negative. 8 Controls Level The level control mixes the selected effect in parallel, adding as much or as little chorus as you want in addition to your direct sound. This means that your tone is preserved while the effect is blended into it. Tone Use this to add brightness or warmth to the sound of the effect without altering your direct sound. Speed This controls the rate or speed of the selected effect. For the rotary effect, this knob acts like a slow/fast switch when it is moved either side of the 12 o'clock position. 9 Controls (continued) Effect Select Knob AFX · Chorus offers eight popular modulation effects, EQ'd to work well with the resonances found in acoustic instruments. Be sure to check them all out in stereo as many can create a very wide, dramatic effect. Chorus 1 This is a very subtle chorus which adds a light detuning and wide stereo image. The chorus effects are built from three "voices" (delays) that are constantly moving and swirling around each other. As you adjust the speed control, the voices chase around more quickly, resulting in more detuned, or chorused, effects. Chorus 2 A thicker and more heavily modulated chorus. Chorus 3 Wide and deep, capable of producing thick to very warbly sounds. 10 Controls (continued) Stereo T remolo When used in stereo, this tremolo sounds more like a traditional panner, moving the audio source from left to right and back again. When used in mono, this tremolo has a very sinusoidal, or even, waveshape, reminiscent of classic surfer songs. [. . . ] This buffered path provides an incredibly low-noise output useful for driving long cable runs, such as to a mixing console. 12 Battery Replacement The clip/batt indicator will light steadily when it is time to change the battery. Open the battery door underneath the pedal and install a fresh 9V alkaline or lithium battery. [. . . ]