User manual FISHMAN AFX REVERB ACOUSTIC EFFECTS PEDAL

[. . . ] The clip/batt LED may flash occasionally. Select an effect ­ Choose one of the eight reverb presets. Dial it in ­ Adjust the level, tone and decay time to taste. [. . . ] Insert a plug into either input jack, and the pedal powers up. To conserve the battery, remove the plug(s) from the input jack(s) when not in use. For AC power, use the Fishman 910-R (for 110V) or other suitable 9V adapter. The adapter must be filtered, regulated and rated for at least 200mA. It must also accept AC power appropriate for your country. Power-plug requirements: 5. 5mm O. D. , 2mm I. D. , tip = negative. Reverb Spillover Normally, when the footswitch is pressed to bypass the effect, the analog audio path is selected and the reverb is cut off abruptly. Instead, you can choose to allow the reverb tails to ring out when in bypass by selecting reverb spillover mode. To do this, power up the the pedal while holding the footswitch until the footswitch light flashes quickly. To revert back to analog bypass, repeat this power-up sequence. 8 Controls Level The level control mixes the selected effect in parallel, adding as much or as little reverb as you want in addition to your direct sound. This means that your tone is preserved while the effect is blended into it. Tone Use this to add brightness or warmth to the sound of the effect without altering your direct sound. Decay Time Adjusts the overall length of the reverb "tail. " 9 Controls (continued) Effect Select Knob AFX · Reverb offers eight popular reverbs, chosen and voiced especially for acoustic instruments. Studio The smallest space in the set, this effect mimcs the sounds of a tightly tuned recording studio space. Room The early reflections and short decay time bring to mind the feel of a small room. Plate Classic warm analog plate reverb used throughout the 50's, 60's and 70's. The original reverberators were large metal plates in wooden housings that had transducers placed at various locations. [. . . ] When the effect is bypassed, your instrument signal passes through an all-analog buffered signal path. This buffered path provides an incredibly low-noise output useful for driving long cable runs, such as to a mixing console. 13 Battery Replacement The clip/batt indicator will light steadily when it is time to change the battery. Open the battery door underneath the pedal and install a fresh 9V alkaline or lithium battery. [. . . ]