User manual FISHMAN AURA PRO

[. . . ] Image tone · Set Play/Edit switch to Edit and adjust tone controls. Move switch back to Play to lock Image tone. Control Feedback · If feedback occurs, push Phase switch. If feedback recurs when you change your location, press switch again. [. . . ] Return to Play and the preamp holds the pickup EQ settings until the Bass, Mid or Treble controls are moved (regardless of the current position of the controls). Programmable Image EQ To EQ an Image, move the Play/Edit switch to Edit. The "#" LED flashes to indicate Edit mode. Move the Blend slider to Aura, select an Image and adjust the tone controls. You can program EQ for each of the four Images: simply select another Image and adjust the controls. Switch to Play and the preamp retains the Image EQ settings, disengages the Image tone controls and enables pickup EQ. Go back to Edit and the preamp holds the Image EQ settings until the Bass, Mid or Treble controls are moved (regardless of the current position of the controls). 11 Phase Switches Phase (global) Use the Phase switch to improve bass response at low volume and suppress feedback at high volume. Push the Phase switch in and out and leave it in the position most pleasing to your ear. If feedback occurs, push the switch again. Relative Phase (pickup phase) To change the character of your blended sound, you may wish to change the phase of the pickup relative to the Image. There is no "best" position for Relative Phase and where you set it is a matter of personal taste. The "#" LED flashes to indicate Edit mode. Push the Tuner button to toggle the relative pickup phase. To exit Relative Phase, move the Play/Edit switch to Play. You can program different Relative Phase settings for each of the four Images. Select a different Image and repeat above procedure. 12 = default. Anti-Feedback Use this search-and-destroy Anti-Feedback filter in addition to the Phase switch. The letter "F" in tuner display will flash. Turn up Volume, then either dampen the strings while tapping the body or play the troublesome note until the feedback begins. The automatic filter will identify and eliminate the feedback. The circuit will hold this offending frequency in memory until you push the Measure button again. [. . . ] 14 15 Restore Factory Defaults 1. Unplug the guitar and move the tone controls to the center detent position. Hold the Anti-Feedback button, plug in the guitar and press the Tuner button within two seconds. When the Tuner "D" LED flashes, release the buttons. [. . . ]