Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual FLAM GMT 44-70. We hope that this FLAM GMT 44-70 user guide will be useful to you.
Lastmanuals help download the user guide FLAM GMT 44-70.
Manual abstract: user guide FLAM GMT 44-70DIMENSIONS
Detailed instructions for use are in the User's Guide.
[. . . ] Removing the Right Side Cover (Figure 1) · Remove the two screws (A). · While lifting the Side Cover (B), pull the top of the Side Cover away from the printer.
A
A
Figure 1
B
5. [. . . ] Removing the Shield (Figure 2) · Remove the three screws (A). NOTE:
B Figure 2
The Shield is keyed at the bottom edge.
6. Removing the Controller Board and Card Cage (Figure 3) · Remove the SIMMs (A). INSTALLATION NOTE: Be sure to install each SIMM in its original location. · Remove the three screws (B) from the bottom of the Card Cage. NOTE: You may have to remove the Network Interface Card to access screw (B3). · · Remove the two screws (C) from the top of the Card Cage. · Controller Board/Card Cage Assembly INSTALLATION NOTE: Make sure to insert the Ribbon Cable through the slot (located above the Fan) in the Card Cage. · · SIMMs Network Interface Card (if removed) INSTALLATION NOTE: At this time, you should close the upper cover, attach the AC Power Cord, turn the printer power ON and print the MENU.
------------------------------------------------------------------------------------------------------------------Did the MENU print?
NO - Turn the printer power OFF, detach the AC Power Cord and raise the Upper Cover. - Remove the Controller Board/Card Cage and make sure all Engine Board Firmware pins are properly inserted into the Engine IC socket. YES - The Program ROM Settings on the Printer Menu will change as follows: PU 02. XX CHANGED TO PU 02. 25
- Turn the printer power OFF, detach the AC Power Cord and raise the Upper Cover. - Continue to install the removed components.
------------------------------------------------------------------------------------------------------------------· · · · · Shield Side Cover AC power cord, Parallel interface cable or Network interface cable and 18 inch parallel interface cable (in a network configuration)
9. Close the Upper Cover, turn the printer power ON. Adjust the printer output (refer to the documentation on the OC8 Software CD). [. . . ] Close the Upper Cover, turn the printer power ON. Adjust the printer output (refer to the documentation on the OC8 Software CD). [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE FLAM GMT 44-70
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual FLAM GMT 44-70 will begin.
