User manual FLORABEST FBC 7 A1

[. . . ] The directives in this warning are there to avoid personal injuries. IMPORTANT A warning at this risk level signifies possible property damage. If the situation is not avoided it could lead to property damage. The directives in this warning are there to avoid property damage. [. . . ] The adapter 10 is used to connect the appliance to water taps with a 26. Should leaks/spills be encountered when using the adapter 10 , it is recommended that you wrap the thread of the tap with Teflon sealing tape. for a 26 , 5 mm thread (G ³/"): Screw the adapter 10 onto the water tap. Screw the coupling nut 6 onto the thread of the water tap resp. Screw the coupling unit 11 onto the hose connection. Slide the two levers upwards to release the clamps 7 . Insert the cable ends of the connection cables into the clamps 7 then slide the two levers down to lock it again. Unlock the battery compartment and pull the battery compartment down and out of the appliance. Push the battery compartment back in the appliance until it clicks into place. The display is switched on, the system time starts at 0:00 and the hour display blinks for a short time. Rotary knob: change adjustable values Button M Button Button ON/OFF Coupling nut Clamps for connection of a rain sensor Hose connection Battery compartment Adapter G1" to G3/4" Coupling unit FBC 7 A1 Meaning System time Time for the next watering Run time/Water flow Battery charge level Display Summer Time Display Rain Sensor Display Watering Weekday Watering interval 11 In this chapter you will receive important information about the operation and programming of the appliance. You can either carry out all settings in succession or, by repeatedly pressing the button M 3 , switch between the following setting options: System time (actual time/weekday) Water flow in % Time for the next watering Duration of the watering Watering interval Standby (Programming mode terminated and watering programme active). After about 1 minute without input the appliance returns to standby mode. All values already programmed are retained. By pressing the button ON/OFF 5 the programming mode can be terminated at any time. All values already programmed are retained. Using the rotary knob 2 enter in the required value and press 4 . Using the rotary knob 2 enter in the required value and press 4 . the clock symbol and a triangle blink the button before the currently programmed weekday. Using the rotary knob 2 enter in the weekday and press the 4 . Repeatedly press the button M 3 until the symbol % and the currently set level for the water flow blink (not necessary if you have already programmed the system time). Using the rotary knob 2 enter in the required value and press 4 . [. . . ] All consumers are statutorily obliged to dispose of batteries at a collection site in their community/city district or at a retail store. This obligation is intended to ensure that batteries are disposed of in an environmentally safe fashion. Only hand in batteries/cells that are fully discharged. (with water flow 200%) 0 - 200% 8/12/24 hours/ 2/3/5/7 days or individual choice of weekday With regard to conformity with essential requirements and other relevant provisions, this appliance complies with the guidelines of the Electromagnetic Compatibility Directive 2004/108/EC. [. . . ]