User manual FLORABEST FRWS 9 A1

[. . . ] In this regard, please read the following assembly instructions attentively. Use this appliance only as described and only for the specified areas of application. Retain these instructions for future reference. [. . . ] –º Exercise caution when deburring with the carpet knife. Drill the hole in the down pipe with the crown drill (see Figure E). Take care to drill with light pressure only, especially in sheet metal downpipes. Then deburr the drillhole with a suitable tool, such as a carpet knife for plastic downpipes or a file with sheetmetal downpipes. Now drill the hole in the rainwater barrel with the crown drill and then deburr the drillhole (see Figure F). 12 08:47 Rainwater collector NOTICE ► With a downpipe size of 70 mm you will need to cut off the rubber tabs at the indentations with scissors (see Figure G). Select the flange ( or ) appropriate to the size of your downpipe. Take note of the size details indicated on the inside of the flanges. Glue one of the flange gaskets into the recess provided on the inside of the flange. To do this, remove the adhesive backing from the flange gasket (see Figure H). Guide the clamping device through the flange. When inserting it, ensure that the guides in the flange grip the rails on the clamping device. Press the two parts firmly together, so that the clamping device engages (see Figure. Turn the nut of the clamping device open such that there is sufficient space between the snap hook and flange. [. . . ] –  Remove any accumulated leaves from the filter and rinse the control valve with a water hose (see Figure N). –  Replace the filter insert back into the control valve and then into the rainwater collector. Disposal Dispose of the appliance through an approved disposal centre or at your community waste facility. [. . . ]