User manual FLUKE Q-RPT

[. . . ] Q-RPT Replacement Kit Instruction sheet This kit includes a replacement Pressure Transducer calibrated to a specific range and class. The kit also contains the following components: DESCRIPTION Crimp terminal Crimp terminal Crimp terminal Crimp terminal Connector Connector Connector Connector Connector CRIMP TOOLS PRODUCT PPC4 PPCH and PPCH-G RPM3, molbox, RPM4, PPC3 QTY 10 10 2 10 1 1 1 1 1 PART NO. [. . . ] 63819-0500 63819-0000 63811-8200 Introduction Only DHI or DHI Authorized Service Providers are authorized to install replacement Q-RPTs. Replacement or installation by other parties will void the warranty of the Q-RPT and possibly the equipment into which it is installed. Measurement and/or control specifications are also valid only under these conditions. Q-RPTs are used in a variety of DHI Controllers, Monitors and Flow Terminals. Different crimps, connectors and associated crimp tools are used with different models. The pages that follow show the crimps, connectors and crimp tool required for each equipment type. Refer to the wiring diagrams on the following sheets and to the detailed Wire Lengths: Specific wire lengths have been intentionally omitted from these instructions. Preferred method is to measure the wire length on the existing Transducer being replaced and cut the wire lengths on the replacement Transducer to same length. Q-RPT must be calibrated after installation. Connector Crimp Terminal Crimp Tool P/N 3141826 P/N 3154579 MolPex P/N: 63819-0500 Figure 1: PPC4 Components and Transducer Wiring Diagram ______________________________________________________________________________________________________________ Connector Crimp Terminal Crimp Tool P/N 2194502 P/N 2207416 MolPex P/N: 63811-8200 Figure 2: RPM3 Components and Transducer Wiring Diagram Connector Crimp Terminal Crimp Tool P/N 1812216 P/N 2207416 MolPex P/N: 63811-8200 Figure 3: molbox1 and molbox1+ Components and Transducer Wiring Diagram ______________________________________________________________________________________________________________ Connector Crimp Terminal Crimp Tool P/N 3154472 (1) P/N 3154485 (7) NOTE: 3154472 HAS LARGER CRIMP BARREL TOACCEPT MULTIPLE WIRES. MolPex P/N: 63819-0000 P/N 3141173 Figure 4: PPCH and PPCH-G Components and Transducer Wiring Diagram Connector Crimp Terminal Crimp Tool P/N 3140008 P/N 2207416 MolPex P/N: 63811-8200 Figure 5: RPM4 and PPC3 Components and Transducer Wiring Diagram Fluke. [. . . ] E-DWT-H and E-DWT are registered trademarks of Fluke Corporation, DH Instruments Division. 2/2010 3339002A D-EN-N Modification of this document is not permitted without written permission from Fluke Corporation. [. . . ]