User manual FLYMO CONTOUR POWER PLUS CORDLESS

[. . . ] Check that the cutting head, spool and cap are fitted correctly. Use the trimmer only in daylight or good artificial light. Avoid operating your trimmer in wet grass, where feasible. Take care in wet grass, you may lose your footing. [. . . ] Before using the machine and after any If over a period of time the battery quickly runs down after a full 24 hour charging period, a replacement battery is needed. There will be some charge present in the battery but to ensure maximum running time, recharge your trimmer for 24 hours before use. Permanent connection to the charger in a well ventilated area will automatically keep your battery fully charged ready for use. Contact your local approved service centre/dealer/distributor for a replacement battery and for safe disposal of your old battery. Battery Replacement Should your battery need to be replaced contact your local approved service centre or dealer who will remove your old battery and fit a genuine Flymo replacement battery. Bench Top Re-charging The wall bracket can also be used as a "bench top" stand for re-charging your cordless trimmer. If you are unable to leave your cordless trimmer on permanent charge, re-charge the battery every 3 to 4 months for a full 24 hour charging period to top up the battery charge during winter storage. Switch charger off at the wall socket before connecting or disconnecting the trimmer to the wall bracket. It is recommended that the wall bracket (F2) should be mounted on a smooth, vertical and internal wall which is strong enough to hold the weight of the product, in a well ventilated area between 5°C and 25°C. Position the wall bracket with the two holes at the top. Ensure that when the trimmer is attached the bottom of the trimmer is within 4 inches (100 mm) of the ground, this will make it easier to hang the trimmer and will also ensure that the wall bracket is within easy reach of an electric socket to allow the charger to be plugged in. Fix wall bracket securely to the wall with the plugs and screws provided. Your cordless trimmer can now be attached to the wall bracket for charging. Keep the charger and the trimmer dry at all times. Keep the charger well ventilated during charging. Ensure the product is correctly located into the wall bracket (F2) and the charge connector (G1). Plug the charger (F1) into a suitable household electrical wall socket and switch on. The red indicator lamp on the product (F3) is a power indicator and will continue to glow red even when the battery is fully charged. Full charge will be achieved in 24 hours after which the indicator lamp on the charger (F4) will turn to green. during charging the charger becomes warm. This is normal and means the charger is operating correctly. Re-charge the battery as soon as the cutting power of your product begins to die and slow down. [. . . ] * The following items listed are considered as wearing parts and their life is dependent on regular maintenance and are, therefore not normally subject to a valid warranty claim: Nylon Line, Spool & Line * Caution!Husqvarna Outdoor Products does not accept liability under the warranty for defects caused in whole or part, directly or indirectly by the fitting of replacement parts or additional parts that are not either manufactured or approved by Husqvarna Outdoor Products, or by the machine having been modified in any way. Bryt strömmen till laddaren innan trimmen ansluts till eller kopplas från väggupphängningen. Genom att se till att denna produkt omhändertas ordentligt kan du hjälpa till att motverka potentiella negativa konsekvenser på miljö och människor, vilka annars kan orsakas genom oriktig avfallshantering av denna produkt. [. . . ]