User manual FLYMO EASI-TRIM EHT530

[. . . ] ) with a tripping current of not more than 30mA is recommended. Installed 100% safety cannot be guaranteed and safe working practice must be followed at all times. Before use, examine cable for damage, replace it if there are signs of damage or ageing. Do not use the product if the electric cables are damaged or worn 4. [. . . ] Mains cables and extensions are available from your local Approved Service Centre. While using your product always wear substantial footwear and long trousers. Make sure the lawn is clear of sticks, stones, bones, wire and debris; they could be thrown by the blade. Before using the machine and after any impact, check for signs of wear or damage and repair as necessary. Use the product only in daylight or good artificial light. Avoid operating your product in wet grass, where feasible. Take care in wet grass, you may lose your footing. On slopes, be extra careful of your footing and wear non-slip footwear. Operate your product across the face of slopes, never up and down. Using on banks and slopes can be dangerous. Do not walk backwards when operating, you could trip. Always handle the blade with care - sharp edges could cause injury. To remove the blade bolt, hold the blade firmly with a gloved hand and with a spanner, loosen the blade bolt by turning it anti-clockwise (R). In the event of a blade becoming difficult to remove, insert a screwdriver (S1) into the hole (S2) to lock the drive, then use a spanner to loosen the blade bolt by turning the spanner anticlockwise. Ensure the screwdriver is removed before atempting to turn on the machine. Renew your metal blade after 50 hours mowing or 2 years whichever is the sooner - regardless of condition. If the blade is cracked or damaged replace it with a new one. Fit the blade to the shaft with the sharp edges of the blade pointing away from the shaft. Hold the blade firmly with a gloved hand and tighten the blade bolt firmly with a spanner . Awareness of the environment must be considered when disposing of `end-of-life' product. If necessary, contact your local authority for disposal information. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. [. . . ] (f) The machine has not been used for hire. (g) The machine is owned by the original purchaser. (h) The machine has not been used commercially. * This guarantee is additional to , and in no way diminishes the customers statutory rights. [. . . ]