User manual FLYMO EASICUT 600XT

[. . . ] Do not repair a damaged cable, replace it with a new one. use only Husqvarna Outdoor Products replacement cable. Always wind cable carefully, avoiding kinking. use only on AC mains supply voltage shown on the product rating label. [. . . ] Keep the cable clear of the cutting area and obstacles at all times. Mains cables and extensions are available from your local Approved Service Centre. The use of safety glasses is recommended. Do not wear loose clothing or jewellery which can be caught in moving parts. Thoroughly inspect the area where the product is to be used and remove all wires and other foreign objects. Before using the machine and after any impact, check for signs of wear or damage and repair as necessary. Always ensure the hand guard supplied is fitted before using the product. Never attempt to use an incomplete product or one with an unauthorised modification. Use the product only in daylight or good artificial light. Avoid operating your product on a wet hedge, where feasible. Know how to stop the product quickly in an emergency. Never operate the product with damaged guards or without guards in place. Remove plug from mains before passing product to another person. Avoid operating while people especially children are nearby. Whilst using the product always be sure of a safe and secure operating position. Keep hands and feet away from the cutting Means at all times and especially when switching on the motor. Remove the plug from the mains :before leaving the product unattended for any period; before clearing a blockage; before checking, cleaning or working on the appliance; if you hit an object. Do not use your product until you are sure that the entire product is in a safe operating condition; if the product starts to vibrate abnormally. Keep all nuts, bolts and screws secure to be sure the product is in safe working condition. Be careful during adjustment of the product to prevent entrapment of the fingers between moving blades and fixed parts of the machine. After use the product should be stored using the blade cover provided. Awareness of the environment must be considered when disposing of `end-of-life' product. [. . . ] (h) The machine has not been used commercially. * This guarantee is additional to , and in no way diminishes the customers statutory rights. Failures due to the following are not covered, therefore it is important that you read the instructions contained in this Operator's Manual and understand how to operate and maintain your machine: Failures not covered by guarantee * Replacing Cutting Line. * Failures as a result of not using the product in accordance with the instructions and recommendations contained in this Operator's Manual. [. . . ]