User manual FLYMO EASIMO EM032 PLUS

[. . . ] Local regulations may restrict the age of the operator. Only use the product in the manner and for the functions described in these instructions. Never operate the product when you are tired, ill or under the influence of alcohol, drugs or medicine. The operator or user is responsible for accidents or hazards occurring to other people or their property. [. . . ] Switch off before pushing the product over surfaces other than grass. Never operate the product with damaged guards or without guards in place. Keep hands and feet away from the cutting means at all times and especially when switching on the motor. Do not tilt product when the motor is running, except when starting and stopping. In this case, do not tilt more than absolutely necessary and lift only the part which is away from the operator. Always ensure that both hands are in the operating position before returning the appliance to the ground. Do not put hands near the grass discharge chute. Never pick up or carry a product when it is operating or still connected to the mains supply. Remove the plug from the mains : - before leaving the product unattended for any period; - before clearing a blockage; - before checking, cleaning or working on the appliance; - if you hit an object. Do not use your product until you are sure that the entire product is in a safe operating condition. Keep all nuts, bolts and screws tight to be sure the product is in safe working condition. Only use the replacement blade and blade bolt specified for this product. Be careful during adjustment of the product to prevent entrapment of the fingers between moving blades and fixed parts of the machine. To ensure you have a secure connection between the lawnmower and the extension cable we strongly recommend you use the following method of attaching the cable: 1. Plug the short connection lead into the socket of the extension cable. Form a loop in the end of the extension cable near to the socket and secure this in the strain relief feature at the top of the switchbox. The Motor is protected by a Thermal Cut-Out which is activated when the blade becomes jammed or if the motor is overloaded. When this occurs, stop and remove the plug from the power supply. The Thermal Cut-Out will only reset when the start/stop lever is released. Clear any obstruction and wait for a few minutes for the Thermal Cut-Out to reset before continuing to use the mower. [. . . ] Failures due to the following are not covered, therefore it is important that you read the instructions contained in this Operator's Manual and understand how to operate and maintain your machine: Failures not covered by guarantee * Failures as a result of not reporting an initial fault. * Failures as a result of sudden impact. * Failures as a result of not using the product in accordance with the instructions and recommendations contained in this Operator's Manual. * Machines used for hire are not covered by this guarantee. [. . . ]