User manual FLYMO FL510DE

[. . . ] Stop the blade if the lawnmower has to be tilted for transportation when crossing surfaces other than grass, and when transporting the lawnmower to and from the area to be mowed. â· Never operate the lawnmower with defective guards, or without safety devices, for example deflectors and/or grass catchers, in place. â· Do not change the engine governor settings or overspeed the engine. Operating the engine at excessive speed may increase the hazard of personal injury. [. . . ] - Refuel outdoors only and do not smoke while refueling. Never remove the cap of the fuel tank or add petrol while the engine is running or when the engine is hot. - If petrol is spilled, do not attempt to start the engine but move the machine away from the area of spillage and avoid creating any source of ignition until petrol vapors have dissipated. Before using, always visually inspect to see that the blades, blade bolts and cutter assembly are not worn or damaged. On multi-bladed machines, take care as rotating one blade can cause other blades to rotate. Tighten the screw properly when reassembling. Do not operate the engine in a confined space where dangerous carbon monoxide fumes can collect. â· Mow only in daylight or in good artificial light. Always be sure of your footing on slopes. â· For wheeled rotary machines, mow across the face of slopes, never up and down. Use extreme caution when reversing or pulling the lawnmower towards you. Keep all nuts, bolts and screws tight to be sure the equipment is in safe working condition. â· Never store the equipment with petrol in the tank inside a building where fumes may reach an open flame or spark. â· Allow the engine to cool before storing in any enclosure. â· To reduce the fire hazard, keep the engine, silencer, battery compartment and petrol storage area free of grass, leaves, or excessive grease. If the fuel tank has to be drained, this should be done outdoors. Mow the lawn twice weekly during the most active periods of growth. Never cut more than 1/3 of the length of the grass, especially during dry periods. Mow with a high cutting height setting the first time. examine the result and lower the mower to the desired setting. Mow slowly or mow the grass twice if it is very long. Always remove the spark plug lead before repair, cleaning or maintenance work. [. . . ] Adjust to desired cutting level by means of the lever at each wheel. Move the lever towards the wheel and set the cutting level. All wheels must be in the same height positions, otherwise uneven cutting will result. Do not drag bag when emptying, it will cause unnecessary wear. [. . . ]