User manual FLYMO PAC A SHREDDER

[. . . ] Always switch off at the mains before disconnecting any plug, cable connector or extension cable. Switch off, remove plug from mains and examine electric supply cable for damage or ageing before winding cable for storage. Do not repair a damaged cable, replace it with a new one. Always wind cable carefully, avoiding kinking. [. . . ] Do not tilt product when the power source is running. Do not fold product when the power source is running. When folding the product for storage please ensure the mains cable is kept clear. Whilst using the product ensure the cable does not become trapped under the wheels or support feet. Do not allow processed material to build up in the discharge area. This may prevent proper discharge and can result in kickback of material through the feed opening. Remove the plug from the mains : - before leaving the product unattended for any period or when transporting; - before clearing a blockage; - before checking, cleaning or working on the appliance; - if the product starts to vibrate abnormally or makes an unusual noise. Keep all nuts, bolts and screws tight to be sure the product is in safe working condition. Do not attempt to repair the product unless you are competent to do so. Check the collection box frequently for wear or deterioration. Only use the replacement parts specified for this product. Be careful during folding of the product to prevent entrapment of the fingers between moving and fixed parts of the machine. Before operating the product, ensure the collection box is correctly located and the Interlock Switch (D1) is securely in place. The product will not start if the Interlock Switch is not located correctly. The product should never be used without the Collection Box in place. To stop the product, turn the control switch anticlockwise back to the O symbol (F1). A push stick is provided to feeding less bulky material into the Feed Inlet (G1) enabling the material to reach the cutting blade. Do not use any other object to push material into the Feed Inlet. overload Reset Button Overloading , jamming the product causes the machine to automatically stop. After a short period of time, press the reset button (H1) and restart the product. When the feed inlet is suddenly blocked, the direction or rotation may switch automatically. Stop the product and after a short period of time, restart. [. . . ] * Machines used for hire are not covered by this guarantee. * The following items listed are considered as wearing parts and their life is dependent on regular maintenance and are, therefore not normally subject to a valid warranty claim: Blades, Electric Mains cable, Cutting Plate * Caution!Husqvarna Outdoor Products does not accept liability under the warranty for defects caused in whole or part, directly or indirectly by the fitting of replacement parts or additional parts that are not either manufactured or approved by Husqvarna Outdoor Products, or by the machine having been modified in any way. Se till att alla muttrar, bultar och skruvar är tillskruvade ordentligt för att se till att maskinen är säker för drift. [. . . ]