User manual FLYMO QUICKSILVER 46

[. . . ] Assemble the handle fit the levers with the pins and clips provided, assemble the wheels as shown and throttle if supplied. Self-Propelled Remove the bail arms, attach cables as shown and re-fit the bail arms, if applicable. Assemble the handle fit the levers with the pins and clips provided, assemble the wheels as shown and throttle if supplied. Always operate with the deflector or grasscatcher in the correct position. [. . . ] Thoroughly inspect the area where the equipment is to be used and remove all objects which may be thrown by the machine. - Store fuel in containers specifically de signed for this purpose. - Refuel outdoors only and do not smoke while refueling. Never remove the cap of the fuel tank or add petrol while the engine is running or when the engine is hot. - If petrol is spilled, do not attempt to start the engine but move the machine away from the area of spillage and avoid creating any source of ignition until petrol vapors have dissipated. Before using, always visually inspect to see that the blades, blade bolts and cutter assembly are not worn or damaged. replace worn or damaged blades and bolts in sets to pre serve balance. On multibladed machines, take care as rotating one blade can cause other blades to rotate. Operation Do not operate the engine in a confined space where dangerous carbon mon ox ide fumes can collect. Mow only in daylight or in good artificial light. avoid operating the equipment in wet grass , where feasible. Always be sure of your footing on slopes. For wheeled rotary machines, mow across the face of slopes, never up and down. Use extreme caution when reversing or pulling the lawnmower towards you. Stop the blade if the lawnmower has to be tilted for transportation when cross ing surfaces other than grass, and when transporting the Lawnmower to and from the area to be mowed. Never operate the lawnmower with defective guards, or without safety de vic es, for example defl ectors and/or grass catchers, in place. Do not change the engine governor settings or overspeed the engine. Operating the engine at excessive speed may increase the hazard of personal injury. disengage all blade and drive clutches before starting the engine. Start the engine or switch on the motor carefully according to instructions and with feet well away from the blade. Do not tilt the lawnmower when starting the engine or switching on the motor, except if the lawnmower has to be tilted for starting. In this case, do not tilt more than absolutely nec es sary and lift only the part which is away from the op er a tor. [. . . ] H) The product has not been used outside of the country in which it was purchased. I) The machine has not been used commercially. This guarantee is additional to, and in no way diminishes the customers statutory rights. Failures due to the following are not covered, therefore it is important that you read the instructions contained in this Operator's Manual and understand how to operate and maintain your machine: Failures not covered by guarantee Replacing worn or damaged blades Failures as a result of not reporting an initial fault. [. . . ]