User manual FLYMO SCIROCCO 2500

[. . . ] Only use the Gardenvac in the manner and for the functions described in these instructions. Never operate the Gardenvac when you are tired, ill or under the influence of alcohol, drugs or medicine. The operator or user is responsible for accidents or hazards occurring to other people or their property. ) with a tripping current of not more than 30mA is recommended. [. . . ] Do not wear clothing with attachments, i. Toggles or drawstrings that can be drawn into the air inlet. Do not use if any part is damaged or broken or if any of the screws are loose. Always check your Gardenvac is in a safe operating condition before use. Use the Gardenvac only in daylight or good artificial light. Do not use the Gardenvac when it is raining or in damp and wet areas. Never use the Gardenvac in or near water or ponds. Know how to stop the Gardenvac quickly in an emergency. Do not walk backwards whilst operating your product, you could trip. On slopes, be extra careful of your footing and wear non-slip footwear. Never pick up or carry the Gardenvac by the cable. Keep children, pets and bystanders at a safe distance when using your Gardenvac. Do not attempt to use your Gardenvac without the fully assembled debris bag fitted. The impeller continues to rotate after your Gardenvac has been switched off. Remove the plug from the mains :- before removing or replacing fully assembled debris bag; - before leaving the Gardenvac unattended for any period; - before clearing a blockage; - before checking, cleaning or working on the appliance; - if the Gardenvac starts to vibrate abnormally. Keep all nuts, bolts and screws tight to be sure the Gardenvac is in a safe working condition. Always store the product in a dry place ensuring the cable is not likely to be damaged on sharp edges etc. When the Suction Tube is locked into the operating position (B2), this is a permanent fixture. The Suction tube cannot be pushed back to its packaged position. Turn the Access Screw 2-4 times clockwise (L) until tight (do not overtighten) · Important:- Your product will not operate if the Access Screw is not tightened. IMPORTANT - WHEN STORING PRODUCT: Always ensure Access Screw is unscrewed back from the switching position by approximately 3 full turns prior to storage. (T) Be careful to ensure the motor housing does not pivot open. [. . . ] (h) The machine has not been used commercially. * This guarantee is additional to , and in no way diminishes the customers statutory rights. Failures due to the following are not covered, therefore it is important that you read the instructions contained in this Operator's Manual and understand how to operate and maintain your machine: Failures not covered by guarantee * Replacing Cutting Line. * Failures as a result of not using the product in accordance with the instructions and recommendations contained in this Operator's Manual. [. . . ]