User manual FLYMO VISIMO VM032 PLUS

[. . . ] While using your product always wear substantial footwear and long trousers. Make sure the lawn is clear of sticks, stones, bones, wire and debris; they could be thrown by the blade. Before using the machine and after any impact, check for signs of wear or damage and repair as necessary. Use the product only in daylight or good artificial light. [. . . ] ) with a tripping current of not more than 30mA is recommended. Installed 100% safety cannot be guaranteed and safe working practice must be followed at all times. Before use, examine cable for damage, replace it if there are signs of damage or ageing. Do not use the product if the electric cables are damaged or worn 4. Immediately disconnect from the mains electricity supply if the cable is cut, or the insulation is damaged. Do not touch the electric cable until the electrical supply has been disconnected. Your extension cable must be uncoiled, coiled cables can overheat and reduce the efficiency of your mower. Keep cable away from product, always work away from the power point mowing up and down, never in circles. Always switch off at the mains before disconnecting any plug, cable connector or extension cable. Switch off, remove plug from mains and examine electric Keep all nuts, bolts and screws tight to be sure the product is in safe working condition. Only use the replacement parts specified for this product. Be careful during adjustment of the product to prevent entrapment of the fingers between moving blades and fixed parts of the machine. Store in a cool dry place and out of reach of children. Allow the product to cool for atleast 30 minutes before storing. T ensure you have a secure connection between the o lawnmower and the extension cable we strongly recommend you use the following method of attaching the cable: 1. Plug the short connection lead into the socket of the extension cable. Form a loop in the end of the extension cable near to the socket and secure this in the strain relief feature at the top of the switchbox. The Motor is protected by a Thermal Cut-Out which is activated when the blade becomes jammed or if the motor is overloaded. When this occurs, stop and remove the plug from the power supply. The Thermal Cut-Out will only reset when the start/stop lever is released. Clear any obstruction and wait for a few minutes for the Thermal CutOut to reset before continuing to use the mower. Switch off, wait until the blade has stopped rotating and disconnect from the mains electricity supply BEFORE attempting to remove or refit the blade. [. . . ] Your product is uniquely identified by a silver and black product rating label. We strongly recommend that your product is serviced at least every twelve months, more often in a professional application. Declare under our sole responsibility that the product(s); Category. 09), 2004/108/EC, 2000/14/EC based on the following EU harmonized standards applied: EN60335-1, EN60335-2-77, EN836, EN50366, EN55014-1, EN61000-3-2, EN61000-3-3 The maximum A weighted sound pressure level LpA at the operators position, recorded on a sample of the above product(s) corresponds to the Level given in the table. [. . . ]