User manual FORD FOCUS-2003

[. . . ] Table of Contents Table of Contents Introduction Instrument Cluster Warning and control lights Gauges 4 10 10 14 Entertainment Systems AM/FM stereo cassette AM/FM stereo with CD 17 17 20 Climate Controls Heater only Manual heating and air conditioning 35 35 36 Lights Headlamps Turn signal control 38 38 41 Driver Controls Windshield wiper/washer control Steering wheel adjustment Power windows Mirrors Speed control 50 50 51 52 53 53 Locks and Security Keys Locks Anti-theft system 62 62 62 65 1 Table of Contents Seating and Safety Restraints Seating Safety restraints Air bags Child restraints 72 72 76 89 95 Driving Starting Brakes Traction control Transmission operation Trailer towing 107 107 111 112 115 122 Roadside Emergencies Getting roadside assistance Hazard flasher switch Fuel pump shut-off switch Fuses and relays Changing tires Jump starting Wrecker towing 125 125 126 126 127 134 138 144 Customer Assistance Reporting safety defects (U. S. only) 145 153 Cleaning 154 2 Table of Contents Maintenance and Specifications Engine compartment Engine oil Battery Fuel information Part numbers Refill capacities Lubricant specifications 161 163 166 170 178 196 196 198 Accessories Index 205 208 All rights reserved. Reproduction by any means, electronic or mechanical including photocopying, recording or by any information storage and retrieval system or translation in whole or part is not permitted without written authorization from Ford Motor Company. Ford may change the contents without notice and without incurring obligation. [. . . ] The belt will click as it retracts to indicate it is in the automatic locking mode. 102 Seating and Safety Restraints 7. Pull the lap belt portion across the child seat toward the buckle and pull up on the shoulder belt while pushing down with your knee on the child seat. 8. Allow the safety belt to retract to remove any slack in the belt. Before placing the child in the seat, forcibly move the seat forward and back to make sure the seat is securely held in place. To check this, grab the seat at the belt path and attempt to move it side to side and forward. There should be no more than one inch of movement for proper installation. Try to pull the belt out of the retractor to make sure the retractor is in the automatic locking mode (you should not be able to pull more belt out). If the retractor is not locked, unbuckle the belt and repeat steps two through nine. Check to make sure the child seat is properly secured before each use. Attaching child safety seats with tether straps Most new forward-facing child safety seats include a tether strap which goes over the back of the seat and hooks to an anchoring point. Tether straps are available as an accessory for many older safety seats. Contact the manufacturer of your child seat for information about ordering a tether strap. The rear seats of your vehicle are equipped with built-in tether strap anchors located behind the seats as described below. The tether anchors in your vehicle are either located under a cover marked with the tether anchor symbol (shown with title) or are recessed bars on the back side of the seatback. 103 Seating and Safety Restraints The tether strap anchors in your vehicle are in the following positions (shown from top view, left is front of the vehicle): Attach the tether strap only to the appropriate tether anchor as shown. The tether strap may not work properly if attached somewhere other than the correct tether anchor. Position the child safety seat on the seat cushion. Route the child safety seat tether strap over the back of the seat. On hatchbacks, the removable luggage area cover must be removed prior to attaching the tether strap to the tether anchor. On wagons, it may be necessary to remove the cargo cover assembly prior to attaching the tether strap to the tether anchor. The tether must not go around the cargo cover retractor assembly. For vehicles with adjustable head restraints, route the tether strap under the head restraint and between the head restraint posts, otherwise route the tether strap over the top of the seatback. [. . . ] 4 Use of sythetic or sythetic blend motor oil is not mandatory. Engine oil need only meet the requirements of Ford specification WSS-M2C153­H and the API Certification mark. LUBRICANT SPECIFICATIONS Item Brake fluid Ford Part Name or Equivalent Motorcraft High Performance DOT 3 Motor Vehicle Brake Fluid Multi-Purpose Grease Ford Part Number PM-1 Ford Specification ESA-M6C25-A and DOT 3 Door latch, hood latch, auxiliary hood latch, trunk latch, seat tracks. Lock cylinder XG-4 or XL-5 ESR-M1C159-A or ESB-M1C93­B Penetrating and XL-1 Lock Lubricant none 198 Maintenance and Specifications Item Automatic transaxle Manual transaxle Ford Part Name or Equivalent Motorcraft MERCON V ATF Motorcraft Full Synthetic Manual Transmission Fluid Motorcraft SAE 5W-20 Premium Synthetic Blend Motor Oil (US) Motorcraft SAE 5W-20 Super Premium Motor Oil (Canada) CV Joint Grease (High Temp. ) Motorcraft Premium Gold Engine Coolant (yellow-colored) Motorcraft MERCON ATF Motorcraft Windshield Washer Concentrate Ford Part Number XT-5-QM Ford Specification MERCON V XT-M5-QS WSD-M2C200­C Engine oil XO-5W20-QSP (US) CXO-5W20­LSP12 (Canada) WSS-M2C153-H and API Certification Mark Constant velocity joints Engine coolant XG-5 VC-7­A WSS-M1C258­A1 WSSM97B51-A1 Power steering fluid Windshield washer fluid XT-2-QDX ZC-32­A MERCON WSB-M8B16­A2 199 Maintenance and Specifications ENGINE DATA Engine Cubic inches Required fuel Firing order Spark plug gap Ignition system Compression ratio 2. 0L SPI engine 121 87 octane 1­3­4­2 1. 4 mm (0. 054 inch) Electronic Ignition 9. 35:1 2. 0L Zetec E engine 121 87 octane 1­3­4­2 1. 3 mm (0. 051 inch) Electronic Ignition 9. 6:1 2. 3L I4 engine 138 87 octane 1­3­4­2 1. 3 mm (0. 051 inch) C. O. P. [. . . ]