User manual FORD SIERRA 91 WIRING DIAGRAMS 1990

[. . . ] Copyright © 2006 Ford Motor Company 3 2007 Crown Victoria (cro) Owners Guide (post-2002-fmt) USA (fus) Introduction CALIFORNIA Proposition 65 Warning WARNING: Engine exhaust, some of its constituents, and certain vehicle components contain or emit chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. In addition, certain fluids contained in vehicles and certain products of component wear contain or emit chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. CONGRATULATIONS Congratulations on acquiring your new Ford. Please take the time to get well acquainted with your vehicle by reading this handbook. [. . . ] · Put the safety belt in the automatic locking mode. Refer to Automatic locking mode (passenger side front and outboard rear seating positions) (if equipped) section in this chapter. · LATCH lower anchors are recommended for use by children up to 48 lb. Top tether anchors can be used for children up to 60 lb. (27 kg) in a child restraint, and to provide upper torso restraint for children up to 80 lb. (36 kg) using an upper torso harness and a belt-positioning booster. Ford recommends the use of a child safety seat having a top tether strap. Install the child safety seat in a seating position with LATCH and 133 2007 Crown Victoria (cro) Owners Guide (post-2002-fmt) USA (fus) Seating and Safety Restraints tether anchors. For more information on top tether straps and anchors, refer to Attaching safety seats with tether straps in this chapter. For more information of LATCH anchors refer to Attaching safety seats with LATCH (Lower Anchors and Tethers for Children) attachments in this chapter. Carefully follow all of the manufacturer's instructions included with the safety seat you put in your vehicle. Tether straps are available as an accessory for many older safety seats. Contact the manufacturer of your child seat for information about ordering a tether strap. The rear seats of your vehicle are equipped with built-in tether strap anchors located behind the seats as described below. The tether anchors in your vehicle are located under a cover marked with the tether anchor symbol (shown with title). The tether strap anchors in your vehicle are in the following positions (shown from top view): Attach the tether strap only to the appropriate tether anchor as shown. The tether strap may not work properly if attached somewhere other than the correct tether anchor. Position the child safety seat on the seat cushion. Route the child safety seat tether strap over the back of the seat. For vehicles with adjustable head restraints, route the tether strap under the head restraint and between the head restraint posts, otherwise route the tether strap over the top of the seatback. Locate the correct anchor for the selected seating position. 137 2007 Crown Victoria (cro) Owners Guide (post-2002-fmt) USA (fus) Seating and Safety Restraints 4. Clip the tether strap to the anchor as shown. [. . . ] Use of any fluid other than the recommended fluid may cause transmission damage. 6 Rear axles are considered lubricated for life when the vehicle is used for normal service. For severe duty requirements, see Exceptions and / or Special Operating Conditions in scheduled maintenance information. 7 Service refill capacities are determined by filling the rear axle 1/4 inch to 9/16 inch (6 mm to 14 mm) below the bottom of the filler hole. [. . . ]