User manual FORD SIERRA COSWORTH WIRING DIAGRAMS 1990

[. . . ] 47 Instrument Panel Controls . . . . . . . . . . . . . . . . . . . . . . . . . . 87 Steering Column Controls . . . . . . . . . . . . . . . . . . . . . . . . 109 Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 121 Electronic Sound Systems . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] NOTE: If the volume level is set above a certain listening level when the ignition switch is turned off, when the ignition switch is turned back on, the volume will come back to a "nominal" listening level. However, if the radio power is turned off (with the "VOL/PUSH ON" button), the volume will remain in the position it was set at when radio power is switched back on (digital systems only). Selecting the AM or FM frequency band Push the "AM/FM" button to select the desired frequency band. Pushing the "AM/FM" button causes the frequency band to switch from "AM" to "FM1" to "FM2" to "AM", changing one band to the next each time the button is pressed. These functions are used with the station memory buttons described under How to tune radio stations. How to tune radio stations There are four ways for you to tune in a particular station. You can use the "TUNE", "SEEK", "SCAN" or memory buttons. 151 u Using the "TUNE" function You can change the frequency up or down one increment at a time by pressing and releasing either the left b or right a side of the "TUNE" button. To change frequencies quickly, press and hold down either the right or left side of the "TUNE" button. Manual tuning adjusts your radio to any allowable broadcast frequency, whether or not a station is present on that frequency. (See All About Radio Frequencies in this section. ) u Using the "SEEK" function Press the right a side of the "SEEK" button to select the next listenable station up the frequency band. Press the left b side of the button to select the next listenable station down the frequency band. (Turn clockwise to shift the sound to the right speakers, and turn counterclockwise to shift the sound to the left speakers. ) Fade control allows you to adjust the sound distribution between the front and rear speakers. The inner ring of the "BAL/FADE" knob adjusts the speaker fader. (Turn clockwise to shift the sound to the rear speakers, and turn counterclockwise to shift the sound to the front speakers. ) 154 Using the Digital Signal Processing (DSP) Feature Push the "DSP" button to activate the feature. The display will indicate which signal mode is in effect. To change the signal mode press either the left b or right a side of the selector button (located under the "DSP" button). The following signal modes may be selected: 1. "HALL" -- Rectangular concert hall capacity of about 2, 000. "CHURCH" -- Church with a high vault. "JAZZ" -- Jazz club with clearly reflected sounds. "STADIUM" -- Outdoor stadium with a capacity of about 30, 000. "NEWS" -- "Voice-only" type of sound with a limited audio band. To deactivate the DSP feature, press the "DSP" button again. Your Antenna Antennas for both AM and FM reception are hidden in the back glass of your vehicle. [. . . ] 177 P Panic alarm feature, remote entry system Parking brake operation . Power steering driving with power steering . 130 182 49, 85 292 292 271 122 155 122 137 141 136 132 144 180 270 291 293 180 138 Index 325 R Radio (see Electronic sound systems) . Remote entry system locking/unlocking doors . [. . . ]