User manual FOSTEX DE-1

[. . . ] 8288 441 100 Owner's Manual Model 20bit Dual Multi Effect Processors DE-1 Owner's Manual CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN ATTENTION: POUR EVITER LES CHOCS ELECTRIQUES, CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). The lightning flash with arrowhead symbol, REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU' AU FOND. "WARNING" "TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. " The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. [. . . ] Powerful stimulation for the three semicircular canals of the inner ear!(B) Special reverb with a deep flanging effect applied. L. HALL 11 (Flange Large Hall 2) * ADJUST knob 1 (PARAM. 1): Reverb Time (adjust the length of reverberation) * ADJUST knob 2 (PARAM. 2): E/R Level (adjust the volume of the early reflections) * ADJUST knob 3 (PARAM. 3): Character (adjust the overtone structure of the reverberation) (cannot be adjusted on L. HALL 1 (Normal Small Hall) (A) Same as DUAL mode S. HALL 1, but higher density reverberation. 8 DE-1 Owner's Manual S. HALL 2 (Lo-Freq Small Hall) (A) Same as DUAL mode S. HALL 2, but higher density reverberation. (Since special processing of the overtone structure is being performed, it is not possible to adjust PARAM. 3 "Character. ") (A) Same as DUAL mode S. HALL 3, but higher density reverberation. HALL 4, but higher density reverberation. HALL 5, but higher density reverberation. HALL 6, but higher density reverberation. HALL 7, but higher density reverberation. HALL 8, but higher density reverberation. HALL 9, but higher density reverberation. (B) Reverb as if moving through a tunnel. Powerful stimulation for the three semicircular canals of the inner ear!(B) Special reverb with a deep and intense flanging effect applied. S. HALL 11 (Flange Small Hall 2) * ADJUST konb 1 (PARAM. 1): Reverb Time (adjust the length of reverberation) * ADJUST knob 2 (PARAM. 2): E/R Level (adjust the volume of the early reflections) * ADJUST knob 3 (PARAM. 3): Character (adjust the overtone structure of the reverberation) (cannot be adjusted on S. HALL 2) ROOM ROOM 1 (Normal Room) ROOM 2 (Garage) (A) Same as DUAL mode ROOM 1, but higher density reverberation. (A) Same as DUAL mode ROOM 2, but higher density reverberation. (Since special processing of the overtone structure is being performed, it is not possible to adjust PARAM. 3 "Character. ") (A) Same as DUAL mode ROOM 3, but higher density reverberation. [. . . ] First, adjust the Input level using the control knob and watch the LED indicator. The best level setting makes the PEAK LED illuminate occasionally. In the case of the sound being distorted in the internal DSP, in spite of no indications on the PEAK LED, this is due to the rise of the entire signal level due to a variety of Effect sounds being used. If this happens, reduce the Input level with the control knob so that the Output sound is not distorted. [. . . ]