User manual FOSTEX RM-2

[. . . ] Heed Warnings - All warnings on the appliance and in the operating instructions should be adhered to. Follow Instructions - All operating and use instructions should be followed. Water and Moisture - The appliance should not be used near water - for example, near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool, and the like. Carts and Stands - The appliance should be used only with a cart or stand that is recommended by the manufacturer. 12. [. . . ] An appliance with a protective earth terminal should be connected to a mains outlet with a protective earth connection. An appliance should be placed in a position where an AC plug / inlet can be easily pulled out by hand. Main plug is used as the disconnection device. It shall remain readily operable and should not be obstructed during intended use. To be completely disconnected the apparatus from supply mains, the mains plug of the apparatus shall be disconnected from the mains socket outlet completely. 2 Model RM-2 Owner's Manual Important Safety Instructions 1) 2) 3) 4) 5) 6) 7) Read these instructions. Install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. 13) Unplug this apparatus during lightning storms or when unused for long periods of time. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. 12) 11) Only use attachments/accessories specified by the manufacturer. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. 8) 14) 9) 10) 3 Model RM-2 Owner's Manual Names and functions After turning on the power Each time you turn on the power, the RM-2 is muted and the "MUTE" indicator flashes. (Figure 1 below shows the condition of the status information section when you first turn on the power after purchasing the RM-2. ) To use the RM-2, therefore, press the [CH SEL] key to unmute the RM-2 (see Figure 2 below). The "MUTE" indicator turns off. In particular conditions, the system mute function works and the RM2 is automatically muted, while you can manually mute it whenever you want. [. . . ] In the cases of (1) and (2) below, muting is released after a few seconds. In the case of (3), muting is released when the unit locks to the external digital signal. (1) When you turn on the power. (2) When you press the [INPUT] switch to switch the input. (3) When the unit does not lock to the external digital clock while selecting the digital input. <Note>: When you turn on the power, both the user mute and system mute functions are activated. [. . . ]