User manual FRANKE FGL6015XS

[. . . ] € If the extractor is used in conjunction with non-electrical appliances (e. Gas burning appliances), a sufficient degree of aeration must be guaranteed in the room in order to prevent the backflow of exhaust gas. The kitchen must have an opening communicating directly with the open air in order to guarantee the entry of clean air. USE • The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells. [. . . ] 1 on the wall as shown about 1-2 mm from the ceiling or upper limit aligning the centre (notch) with the vertical reference line. € Mark the wall at the centres of the holes in the bracket. 1 on the wall as shown at X mm below the first bracket (X = height of the upper chimney section supplied), aligning the centre (notch) with the vertical line. € Mark the wall at the centres of the holes in the bracket. € Mark a reference point as indicated at 116 mm from the vertical reference line and 306 mm above the horizontal reference line. € Repeat this operation on the other side. • Drill ø 8 mm holes at all the centre points marked. € Insert the wall plugs 11 in the holes. 1 and the air outlet connection support 7. 3 together using the 2 screws 12a (4, 2 x 44, 4) supplied. € Insert the two screws 12a (4, 2 x 44, 4) supplied in the hood body fixing holes, leaving a gap of 5-6 mm between the wall and the head of the screw. Net 5 5 Mounting the hood body • Before attaching the hood body, tighten the two screws Vr located on the hood body mounting points. € Hook the hood body onto the screws 12a. • Fully tighten the support screws 12a. € Adjust the screws Vr to level the hood body. Vr 12a Connections DUCTED VERSION AIR EXHAUST SYSTEM When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 120 mm, the choice of which is left to the installer. € To install a ø 120 mm air exhaust connection, insert the reducer flange 9 on the hood body outlet. € Fix the pipe in position using sufficient pipe clamps (not supplied). • Remove any activated charcoal filters. ø 150 9 ø 120 RECIRCULATION VERSION AIR OUTLET • Insert the connection extension pieces laterally 14. € Insert the Connector 15 into the Support bracket 7. € Make sure that the outlet of the extension pieces 14. [. . . ] Net 8 8 MAINTENANCE Grease filters CLEANING METAL SELF- SUPPORTING GREASE FILTERS • The filters must be cleaned every 2 months of operation, or more frequently for particularly heavy usage, and can be washed in a dishwasher. € Remove the filters one at a time by pushing them towards the back of the group and pulling down at the same time. € Wash the filters, taking care not to bend them. € When refitting the filters, make sure that the handle is visible on the outside. [. . . ]