User manual FRANKE SMP 66 M XS/F

[. . . ] Switching on the first time How to read the cooking table This user manual applies to several models of the device. Thus it may be possible that some of the described features and functions are not available on your specific model. The explanatory images and figures, described in the various sections, are available at the end of the manual. FRANKE reserves the right to make modifications to the product without prior notice. [. . . ] Note: The grill heating element is very hot when in use; be Careful not to touch it accidentally when handling food to be In any case, FRANKE has designed the oven opening to Protect hands as much as possible. TURBO GRILL COOKING The grill heating element at the top of the oven and the fan are The thermostat knob (D) should activated. The LED will blink for the next 10 seconds (for Possible adjustments), after which the setting will be acquired and the LED becomes steady. The same effect is obtained by pressing the right knob twice during blinking. At the end of cooking, oven heating will be deactivated and the ringer will sound for 1 minute; this sound can be stopped by pressing the right knob. Note: At the end of cooking, the oven remains at a temperature close to the previously set value for several minutes; it is therefore wise to remove the food from inside so as to avoid overcooking it. End of cooking with delayed start XXDelayed start of cooking can only be activated Following the end of a cooking process; when set, pressing the right knob confirms the , , stop", and at the same activates the blinking LED for the symbol . XXTurn the left knob to also set the start of cooking time (naturally this will be before the end, therefore the hands can only be moved back). XXThe data can also be automatically acquired by allowing the blinking to continue for 10 seconds. The LEDs for symbols and will remain lit and the oven will switch on at the set time, when only the LED for the symbol will remain lit. At the end of cooking, the ringer will sound for 1 minute; this sound can be stopped by pressing the right knob. Setting the time of day XXTo set the correct time, just press the right knob Three times (the LED for the clock symbol starts blinking), then turn the left knob. XXAfter setting the right time, press the right knob to confirm. 1b, 1c) It enables oven programming in the following modes: ­­ delayed start of cooking with set duration, ­­ immediate start of cooking with set duration; ­­ timer. Setting the digital clock When the appliance has been connected to the mains or after a power failure the display will flash on: , , 0. XXPress the + and - buttons B together for a few seconds. The time of day can be adjusted with the + and - buttons, while the dot between the hours and minutes flashes. Possible time adjustments can be made by repeating the steps described above. The frequency of the acoustic signal can be changed if a cooking cycle is not programmed (therefore the display shows the time of day). XXPress the + and - buttons (from the time modification menu) together. XXPress Mode or Set to select the menu for modifying the acoustic signal frequency. XXThe acoustic signal frequency can be modified by repeatedly pressing the Mode or Set button; , , ton1", , , ton2", , , ton3" will appear on the display. [. . . ] By disposing of the device in a proper way you help to avoid harmful consequences to environment and health. Further information about recycling the device is available from the competent authority, the local refuse disposal service or the vendor of the device. Dispose of the device, which is to be discarded, via a specialised waste collection point for electronic and electrical devices. In accordance with the Directive 2012/19/EU, regarding the reduction of the hazardous substances used in electrical and electronic appliances, and waste disposal. [. . . ]