User manual FREECOM AIT-SDX560

[. . . ] SDX-560V/P SDX-560V/RP 5. 25"Model Product Specification Manual Version 1. 0 Dec. 2004 Copyright © 2004, Sony Corporation. NOTE: This Product Specification Manual is applicable for AIT-2 Turbo ATAPI I/F drive. Notice This document contains proprietary information which is protected by copyright. No part of this document may be photocopied, reproduced or translated to another language without prior written consent of Sony. [. . . ] The drive always powers-up with its default configurations set. This is also true, if the drive receives a Software Reset, or a Hardware Reset. PF: The Page Format bit indicates that the data sent by the Host after the MODE SELECT header and block descriptors complies with the definition of pages as set out in SCSI-2. SP: The Save Parameters bit instructs the drive to save all savable pages. This bit is not supported and the drive will return a CHECK CONDITION status with an ILLEGAL REQUEST sense key, if it is set. The Parameter List Length field specifies the length in bytes of the MODE SELECT parameter list that shall be transferred to the Device as data. A Parameter List Length of zero indicates that no data shall be transferred. This condition shall not be considered as an error. A Parameter List Length that results in the truncation of any descriptor, header or page of parameter shall cause the Device to terminate the command with "Check Condition" status. The Sense Key shall be set to ILLEGAL REQUEST, and the Additional Sense Code shall be set to PARAMETER LIST LENGTH ERROR. The Device shall terminate the MODE SELECT command with "Check Condition" status, set the Sense Key to ILLEGAL REQUEST and set the Additional Sense Code to INVALID FIELD IN PARAMETER LIST for the following conditions: 1. An attempt to send an unsupported value in the MODE SELECT header, block descriptor, or any page header. An attempt to send a page with a length not equal to the parameter length reported for that page by the MODE SENSE command. An attempt to send a value for a parameter that is outside the range supported by the Device and rounding is not implemented for that parameter. SONY AIT-2 Turbo drive SDX-560V series Ver. 1. 0 7-23 7. ATAPI Packet Command Specification MODE SELECT Table 7-30: MODE PAGE Mode Parameter Header Bit Byte 0 1 2 3 4 5 6 7 8 9 10 11 Reserved Reserved WP (MSB) Number of Blocks (00 00 00h) (LSSB) Reserved (MSB) Block Length (LSB) Buffered Mode (001b) Block Descriptor Length (08h) Density Code (30h) Speed (00h) 7 6 5 4 3 2 1 0 Buffered Mode: Buffered Mode is the mechanism by which the drive implements Immediate Reporting on WRITE commands. The Buffered Mode field is one indicating the drive reports GOOD status on WRITE commands as soon as the data block has been transferred to the buffer. This is the default configuration for the drive. Speed: The drive only supports one speed, the default speed. Because of this, this field must be set to ZERO. Any other value will cause a CHECK CONDITION status with an ILLEGAL REQUEST sense key is returned. Block Descriptor Length: This specifies the length in bytes of all the block descriptors. Since the drive only allows one block descriptor, this value must be eight. [. . . ] APPENDIX A: ASC & ASCQ Alphabetic Order 3F 2A 00 28 4E 1A 26 26 2A 47 03 27 15 29 2A 2A 3B 39 45 00 33 11 50 0C 27 01 01 00 00 00 00 01 02 00 00 00 04 02 00 05 03 08 00 00 03 00 00 00 00 00 MICROCODE HAD BEEN CHANGED MODE PARAMETERS CHANGED NO ADDITIONAL SENSE INFORMATION NOT READY TO READY TRANSITION (MEDIUM MAY HAVE CHANGED) OVERLAPPED COMMANDS ATTEMPTED PARAMETER LIST LENGTH ERROR PARAMETER NOT SUPPORTED PARAMETER VALUE INVALID PARAMETERS CHANGED PARITY ERROR PERIPHERAL DEVICE WRITE FAULT PERSISTENT WRITE PROTECT POSITIONING ERROR DETECTED BY READ OF MEDIUM POWER ON, RESET, OR BUS DEVICE RESET OCCURRED REGISTRATION PREEMPTED RESERVATION PREEMPTED REPOSITION ERROR SAVING PARAMETER NOT SUPPORTED SELECT OR RESELECT FAILURE SETMARK DETECTED TAPE LENGTH ERROR UNRECOVERED READ ERROR WRITE APPEND ERROR WRITE ERROR WRITE PROTECTED 9-2 SONY AIT-2 Turbo drive SDX-560V series Ver. APPENDIX B: ASC & ASCQ Numeric Order 10. APPENDIX B: ASC & ASCQ Numeric Order ASC and ASCQ Assignments Numeric Order BYTE 12 00 00 00 00 00 00 03 04 04 0C 11 11 14 15 15 1A 20 24 25 26 26 26 27 27 28 29 29 2A 2A 2A 2A 2C 30 13 DESCRIPTION 00 01 02 03 04 05 00 00 01 00 00 08 03 01 02 00 00 00 00 00 01 02 00 04 00 00 80 00 01 03 05 00 00 NO ADDITIONAL SENSE INFORMATION FILEMARK DETECTED END-OF-PARTITION/MEDIUM DETECTED SETMARK DETECTED BEGINNING-OF-PARTITION/MEDIUM DETECTED END-OF-DATA DETECTED PERIPHERAL DEVICE WRITE FAULT LOGICAL UNIT NOT READY, CAUSE NOT REPORTABLE LOGICAL UNIT IS IN PROCESS OF BECOMING READY WRITE ERROR UNRECOVERED READ ERROR INCOMPLETE BLOCK READ END-OF-DATA NOT FOUND MECHANICAL POSITIONING ERROR POSITIONING ERROR DETECTED BY READ OF MEDIUM PARAMETER LIST LENGTH ERROR INVALID COMMAND OPERATION CODE INVALID FIELD IN CDB LOGICAL UNIT NOT SUPPORTED INVALID FIELD IN PARAMETER LIST PARAMETER NOT SUPPORTED PARAMETER VALUE INVALID WRITE PROTECTED PERSISTENT WRITE PROTECT NOT READY TO READY TRANSITION (MEDIUM MAY HAVE CHANGED) POWER ON, RESET, OR BUS DEVICE RESET OCCURRED DRIVE FAILED POWER-ON TEST OR DIAGNOSTIC - (SONY Unique) PARAMETERS CHANGED MODE PARAMETERS CHANGED RESERVATION PREEMPTED REGISTRATION PREEMPTED COMMAND SEQUENCE ERROR INCOMPATIBLE MEDIUM INSTALLED SONY AIT-2 Turbo drive SDX-560V series Ver. APPENDIX B: ASC & ASCQ Numeric Order 30 30 31 33 39 3A 3B 3D 3E 3F 43 44 45 47 48 49 4A 4B 4E 50 52 55 5D 70 83 02 03 00 00 00 00 08 00 00 01 00 00 00 00 00 00 00 00 00 00 00 04 00 NN 87 CANNOT READ MEDIUM - INCOMPATIBLE FORMAT CLEANING CARTRIDGE INSTALLED MEDIUM FORMAT CORRUPTED TAPE LENGTH ERROR SAVING PARAMETER NOT SUPPORTED MEDIUM NOT PRESENT REPOSITION ERROR INVALID BITS IN IDENTIFY MESSAGE LOGICAL UNIT HAS NOT SELF-CONFIGURED YET MICROCODE HAD BEEN CHANGED MESSAGE ERROR INTERNAL TARGET FAILURE SELECT OR RESELECT FAILURE PARITY ERROR INITIATOR DETECTED ERROR MESSAGE RECEIVED INVALID MESSAGE ERROR COMMAND PHASE ERROR DATA PHASE ERROR OVERLAPPED COMMANDS ATTEMPTED WRITE APPEND ERROR CARTRIDGE FAULT INSUFFICIENT REGISTRATION RESOURCES FAILURE PREDICTION THRESHOLD EXCEEDED DECOMPRESSION EXCEPTION SHORT ALGORITHM ID OF NN BROKEN MIC IS LOADED IN AIT MODE 10-2 SONY AIT-2 Turbo drive SDX-560V series Ver. [. . . ]