User manual FREECOM LTO 460I

[. . . ] 8OWULXP *HQHUDWLRQ , QWHUQDO 7DSH 'ULYHV *HWWLQJ 6WDUWHG *XLGH Contents Read the "Pre-Installation" and "Installing the tape drive" sections if you have to install or replace your Ultrium Generation 2 tape drive. If you have purchased your tape drive preinstalled in a server, go directly to the operating and troubleshooting information commencing on page 23. Pre-Installation Before you start Backup software and drivers page 3 page 5 Installing the tape drive Step 1: Check the SCSI connection Step 2: Check the drive's SCSI ID Step 3: Prepare the mounting bay Step 4: Attach mounting hardware Step 5: Install the drive Step 6: Attach power and SCSI cables Step 7: Secure the drive Step 8: Verify installation page 7 page 9 page 11 page 13 page 15 page 17 page 19 page 21 Using the tape drive Your Ultrium Generation 2 tape drive Use the correct media Optimizing performance Troubleshooting Understanding the LEDs Problems with cartridges page 23 page 25 page 27 page 29 page 33 page 36 1 Copyright © 2003 by Hewlett-Packard Limited. February 2003 This document was produced for your tape drive or library vendor by Hewlett-Packard. The information contained in this document is subject to change without notice. [. . . ] Figure 10 illustrates the location of the write-protect tab. Write-protection will not prevent a cartridge being erased by bulk-erasure or degaussing. Do not bulk erase Ultrium format cartridges. This will destroy pre-recorded servo information and make the cartridge unusable. Cleaning cartridges You must use Ultrium cleaning cartridges with Ultrium Generation 2 tape drives, as other cleaning cartridges will not load and run. We recommend the Ultrium Universal cartridge. Unlike some earlier Generation 1 Ultrium cleaning cartridges, the orange colored Ultrium Universal cleaning cartridge is designed to work with any Ultrium compliant drive. Do not use other format cartridges in your tape drive and do not use Ultrium cartridges in other format tape drives. To clean the tape drive: A cleaning cartridge is supplied with each tape drive and should only be used when the orange Clean LED is flashing. 1 2 Insert the cleaning cartridge. The drive will carry out its cleaning cycle and eject the cartridge on completion (which can take up to 5 minutes). During the cleaning cycle the orange Clean LED will be on solidly and the green Ready LED will flash. Each cleaning cartridge can be used up to 15 times. If the cleaning cartridge is ejected immediately with the Tape Error LED on, it has expired. 25 Looking after cartridges · Do not touch the tape media. · Do not attempt to clean the tape path or tape guides inside the cartridge. · Do not leave cartridges in excessively dry or humid conditions. Do not leave cartridges in direct sunlight or in places where magnetic fields are present (for example, under telephones, next to monitors or near transformers). · Do not drop cartridges or handle them roughly. · Stick labels onto the label area only. · Do not bulk erase Ultrium format cartridges. · See the insert included with the tape cartridge for storage conditions. 26 Optimizing performance Various factors can affect tape drive performance, particularly in a network environment or if the drive is not on a dedicated SCSI bus. If your tape drive is not performing as well as expected, consider the following points. Is the tape drive on a dedicated SCSI bus? For optimum performance, we recommend that the tape drive is the only device on the SCSI bus. If it is not, ensure other devices are LVD-compliant. If they are single-ended, the bus will switch to single-ended mode with a lower transfer speed. There will also be restrictions on cable length. Can your system deliver the required performance? The Ultrium Generation 2 tape drive can write data at 30 MB/s (native) or 60 MB/s (compressed - assuming 2:1 compression), however, to get this performance it is essential that your whole system can deliver this performance. [. . . ] with Tape Error and Clean Upgrade the firmware. If the condition persists, call for OFF. repeatedly. The drive has a firmware error. 35 Problems with cartridges If you experience any problems using Ultrium branded cartridges, check: · The cartridge case is intact and that it contains no splits, cracks or damage. · The cartridge has been stored at the correct temperature and humidity. [. . . ]