User manual FREECOM LTO-4 VOLUME 1

[. . . ] HP LTO Ultrium tape drives technical reference manual LTO4 FC, SCSI and SAS drives volume 1: hardware integration Edition 1, June 2007 HP restricted Legal and notice information © Copyright 2005­2007 Hewlett-Packard Development Company, L. P. Hewlett-Packard Company makes no warranty of any kind with regard to this material, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. Hewlett-Packard shall not be liable for errors contained herein or for incidental or consequential damages in connection with the furnishing, performance, or use of this material. This document contains proprietary information, which is protected by copyright. [. . . ] Cannot perform operation because the SCSI burst size is zero or unknown. Command not supported because the primary interface has not been enabled. An ADI frame has been received while one or more ACI commands are outstanding. An SOF was received in ACI Mode which was not a valid frame. The SSC device has not requested the amount of data supplied with the ACI SCSI command. The specified automation port is not supported. ACI self-test failure -- the ACI should not be executing a direct Command while performing the self-test. ACI self-test failure -- the ACI should not be executing a slow Command while performing the self-test. ACI self-test failure -- if the ACI is idle, the Control queue should be empty. ACI self-test failure -- if the ACI is idle, the Response queue should be empty. ACI self-test failure -- if the ACI is idle, the Surrogate SCSI queue should be empty. ACI self-test failure -- if the ACI is idle, only the self-test command should be allocated in the small Data Region. ACI self-test failure -- if the ACI is idle, no memory from the Large Data Region should be allocated. ACI self-test failure -- if the ACI is idle, no CRAM memory should be allocated. ACI self-test failure -- if the ACI is idle, only one CCB should be allocated. Buffer manager (from 0800h) Code 0800h 0801h 0802h 0803h 0804h 0805h Description The buffer manager failed to initialize correctly. No Buffer Allocation description exists for the supplied Module ID. The priority request queue has overflowed. Dataset index error: BMMDataSetIdxToAddr() has been passed an invalid Idx. Dataset information table index error: BMMDataSetIdxToDSITAddr() has been passed an invalid Idx. 94 Drive error codes HP restricted Code 0806h 0807h 0808h 0809h Description ACN index error: BMMDataSetIdxToACNandLPOSAddr() has been passed an invalid Idx. Wrap index error: BMMDataSetIdxToWrapAddr() has been passed an invalid dataset Idx. The notification was not SDL signal for DSIT read. See BMMXferComplete() . Diagnostic control (from 1800h) Code 1800h 1801h 1802h 1803h 1804h 1805h 1806h 1807h 1808h 1809h 180Ah 180Bh 180Ch 180Dh 180Eh 180Fh 1810h 1820h 1821h 1822h 1823h 1830h 1831h 1840h 1841h 1842h 1843h Description No errors. [. . . ] The host has access to all command operations, including those that access the tape, set configurations and run diagnostic tests. A Fibre Channel topology in which two points communicate directly. network NL_port node offline online point-to-point N_port port private loop private NL_port public loop N_port N_port F_port An access point in a device to which a link attaches. An arbitrated loop that has no attached switch port (NL-port to NL_port). In theory, private loop devices can only communicate with other devices on the same loop. [. . . ]