User manual FREESTYLE SHARK MAKO

[. . . ] To select between these features, press Reset button RB until the desired function (noted by its respective flag) is displayed. TIMER COUNTDOWN - " " flag will be displayed. This function will countdown from a preset time. When the countdown time is reached, the timer will beep and will automatically reset to the preset time. #788 MAKO WATCH INSTRUCTIONS FEATURES · CURRENT TIME (HR. , MIN. , & SEC. ) · DAY/MONTH/DATE · CHRONOGRAPH WITH SPLIT OR LAP TIMES · DUAL ALARMS ( 1 DAILY REPEATING, 1 NONREPEATING REMINDER. ) · COUNTDOWN STOP COUNTDOWN REPEAT, COUNTDOWN CHRONO LAP & COUNTDOWN CHRONO SPLIT TIMERS · DUAL TIME · HOURLY CHIME · OPTIONAL 24-HR. [. . . ] This chronograph has a chrono lap timer, identical to that in the chronograph/stopwatch "LP" mode. To stop chronograph, press Start/Stop button RT. Reset the chronograph to zero by pressing the Reset button RB. Lap time is the time elapsed since the previous lap. To use the lap time feature, "LP" flag must be displayed. Reset the chronograph to zero by pressing the Reset button RB. Enter Lap mode by pressing Light/Set button LT. Press Start/Stop button RT to start chronograph. "LP" flag will begin flashing. The chronograph will start counting next lap while lap time is displayed. To release lap time and return to running chrono, press Reset button RB. Each press of Reset button RB will display a lap time. Press Light/Set button LT to exit the alarm setting mode. To activate the alarm while in alarm mode: Press Start/Stop button RT to arm or disarm the alarm " " and/or hourly chime " ". Note the setting sequence is: alarm on, chime on, both alarms and chime on, both alarms and chime off. TIMER COUNTDOWN CHRONO SPLITPress Lap/Reset button RB; "C", " " and " " flags will be displayed. This function will countdown from a preset time. When the countdown time is reached, the timer will beep and automatically start a chronograph. This chronograph has a chrono split timer, identical to that in the chronograph/stopwatch " " mode. To set the countdown time, press and hold the Light/Set button LT for approximately three seconds. To advance the flashing minutes digit, press Start/Stop button RT. To set minutes, press Mode button LB; single minutes digit will flash. To advance flashing minutes digit, press Start/Stop button RT; hold for rapid advance. To set tens of minutes, press Mode button LB; tens of minutes will flash. To advance flashing tens of minutes press Start/Stop button RT; hold for rapid advance. Continuing through the setting mode, the setting sequence is a continuous loop of: seconds · single minutes · tens of minutes To stop chronograph, press Start/Stop button RT. [. . . ] This warranty applies to watches purchased in the United States. For watches purchased outside the United States, please contact your authorized Freestyle® dealer for warranty information. If your watch requires servicing not covered under our warranty (battery, crystal, strap/bracelet/band, watch case plating), or refurbishing, complete the return form (next column) and return with your watch. Continue through the setting sequence as done in normal time setting by cycling between Mode button LB and Start/Stop button RT. Press Light/Set button LT to exit the setting mode. [. . . ]