User manual FRIGIDAIRE ELECTRIC RANGES WITH ES 540 SERVICE DATASHEET

[. . . ] The following are examples, but without limitation, of such practices. Before servicing or moving an appliance remove power cord from electrical outlet, trip circuit breaker to OFF, or remove fuse. Never interfere with the proper installation of any safety device. GROUNDING: The standard color coding for safety ground wires is GREEN or GREEN WITH YELLOW STRIPES. [. . . ] The current calibration offset (temperature adjustment) should appear in the temperature display. Use the number key pads (0-9) to enter the desired amount of adjustment (up to 35°F). Press the CLEAN key pad to change the sign of the adjustment to a (-) if necessary. A positive adjustment will not display a sign. Once the desired adjustment (-35° to 35° F) has been entered, press the START key pad to accept the change or the STOP/CLEAR or CANCEL key pad to reject the change. Note: Changing calibration affects all Baking modes. The adjustments made will not change the self-cleaning temperature. Electronic Oven Control & Jumper Connections (EOC Rear View) Resistance Temperature Detector (RTD) Resistance Temperature Detector Scale RTD SCALE Temperature (°F) 32 ± 1. 9 75 ± 2. 5 250 ± 4. 4 350 ± 5. 4 450 ± 6. 9 550 ± 8. 2 650 ± 9. 6 900 ± 13. 6 Resistance (ohms) 1000 ± 4. 0 1091 ± 5. 3 1453 ± 8. 9 1654 ± 10. 8 1852 ± 13. 5 2047 ± 15. 8 2237 ± 18. 5 2697 ± 24. 4 Electonic Oven Control Fault Code Descriptions Fault Code F10 F11 F12 F13 F20 Likely Failure Condition/Cause Runaway Temperature. Bad EEPROM Identification/Checksum error. Communication failure between EOC & ESEC system (for electric range models ONLY) Communication failure with Mini Oven Control Board. (for models equipped with Bake-n-WarmTM ONLY) Shorted Probe connection. Suggested Corrective Action 1. (F10 only) Check RTD Sensor Probe & replace if necessary. If oven is overheating, disconnect power. If oven continues to overheat when the power is reapplied, replace EOC. Severe overheating may require the entire oven to be replaced should damage be extensive. (F11, 12 & 13) Disconnect power, wait 30 seconds and reapply power. (F11, 12 & 13) If fault returns upon power-up, replace EOC. 1. Test harness/connections P4 (EOC) & P7 (Surface Element Control Board) 2. failure can be caused by faulty UIB, Surface Element Control Board or EOC. Check harness & connectors from the EOC to Mini Oven Control Board. [. . . ] (F90)Lock Motor continuosly runs - if Micro Switch is open, replace Lock Motor Assembly. (F90) Check oven door Light Switch - if open, replace Switch. If all situations above do not solve probem, replace EOC. F26 F30 F31 F90 F91 F92 F93 F94 F95 Maximum oven door unlock time exceeded. Maximum oven door unlock attempts exceeded. [. . . ]