User manual FRIGIDAIRE FAQG7001LW INSTALLATION

[. . . ] For your safety the information in this manual must be followed to minimize the risk of fire or explosion or to prevent property damage, personal injury or loss of life. Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. Read all of the following instructions before installing and using this appliance: Destroy the carton and plastic bags after the dryer is unpacked. Cartons covered with rugs, bedspreads, or plastic sheets can become airtight chambers causing suffocation. [. . . ] 6 Installer MUST anchor this (1) dryer or (2) dryer mounted on pedestal to the floor with approved Mobile Home Installation Kit - P/N 137067200. EXPLOSION HAZARD Do not install the dryer where gasoline or other flammables are kept or stored. Failure to do so can result in death, explosion, fire or burns. DO NOT INSTALL YOUR DRYER: 1 In an area exposed to dripping water or outside weather conditions. 2 In an area where it will come in contact with curtains, drapes, or anything that will obstruct the flow of combustion and ventilation air. Floor MUST be solid with a maximum slope of 1 inch (2. 1 A dryer installed in a bedroom, bathroom, recess or closet, MUST be exhausted outdoors. 2 No other fuel burning appliance shall be installed in the same closet as the gas dryer. 3 Your dryer needs the space around it for proper ventilation. DO NOT install your dryer in a closet with a solid door. 4 Closet door ventilation required: A minimum of 120 square inches (774. 2 cm²) of opening, equally divided at the top and bottom of the door, is required. Openings are required to be unobstructed when a door is installed. * Dryer must be vented straight back to achieve 0" (0 cm) rear installation. Freestand dryer on floor floor line Floor line * To obtain these minimal depth dimensions, dryer must be vented straight back. Using a quick-turn 90° elbow (right or down on freestanding dryer) adds approximately 0. 5cm)* to front of closed door * To obtain these minimal depth dimensions, dryer must be vented straight back. If in doubt, call a licensed electrician. 3 DO NOT modify the plug you've installed on this appliance. If it will not fit the outlet, have a proper outlet installed by a qualified electrician. For a permanently connected dryer: 1 The dryer MUST be connected to a grounded metal, permanent wiring system; or an equipment grounding conductor must be run with the circuit conductors and connected to the equipmentgrounding terminal or lead on the appliance. ELECTRICAL SHOCK HAZARD Improper connection of the equipment grounding conductor can result in a risk of electrical shock. [. . . ] Reinstall plastic plug in the square hole next to the hinge. Take care not to strip out the plastic holes. Take care not to strip out the plastic holes. 5 Locate new metal strike supplied with dryer manuals. [. . . ]