User manual FRIGIDAIRE FPDS3085K WIRING DIAGRAM REV A

[. . . ] A"T" handle type manual gas valve must be installed in the gas supply line to this appliance. These surfaces should be flat & leveled (hatched area). Do not install the unit in the cabinet before reading next page. NOTE: Wiring diagram for these appliances are enclosed in this booklet. [. . . ] In the circuit breaker, fuse box or junction box: a) Connect the green (or bare copper) wire, the white appliance cable wire, and the neutral (white) wire together. Be sure that no power is supplied on the cable from residence. Remove the grounding strap from the terminal block and from the appliance frame. In the circuit breaker, fuse box or junction box: a) Connect the white appliance cable wire to the neutral (white) wire. D) Connect the green (or bare copper) grounding wire to the grounding wire of the circuit breaker, fuse box or junction box. Cable from Residence Green (or Bare Copper) Wire White Wire Red Wires Black Wires Green (or Bare Copper) Wire White Wire Junction Box Cable from Appliance NOTE: Be sure to remove the supplied grounding strap. Junction Box White Wire Green (or Bare Copper) Wire Cable from Appliance NOTE: Be sure to remove the supplied grounding strap. To eliminate the risk of burns or fire by reaching over heated surface units, do not have cabinet storage space above the range. If there is cabinet storage space above range, reduce risk by installing a range hood that projects horizontally a minimum of 5" (12. 5 kPa) manifold pressure; the inlet pressure must be at least 11"(27, 9 cm) water column (2. The supply line should be equipped with an approved shutoff valve (see Figure 10). 25 kPa) greater than the regulator manifold pressure setting. (Models with an Electric Oven and a Gas Cooktop) The supply line must be equipped with an approved manual shutoff valve. This valve should be located in the same room as the range and should be in a location that allows ease of opening and closing. do not block access to the shutoff valve. The valve is for turning on or shutting off gas to the appliance. once regulator is in place , open the shutoff valve in the gas supply line. Wait a few minutes for gas to move through the gas line. After connecting the range to the gas supply, check the system for leaks with a manometer. If a manometer is not available, turn on the gas supply and use a liquid leak detector at all joints and connections to check for leaks. Do not use a flame to check for leaks from gas connections. Checking for leaks with a flame may result in a fire or explosion. [. . . ] The serial plate is located on the oven front frame behind the oven door (some models) or on the drawer side frame (some models). When ordering parts for or making inquiries about your range, always be sure to include the model and serial numbers and a lot number or letter from the serial plate on your range. Your serial plate also tells you the rating of the burners, the type of fuel and the pressure the range was adjusted for when it left the factory. Read the Avoid Service Checklist and operating instructions in your Use and Care Guide. [. . . ]