User manual FRIGIDAIRE FPF523TCW

[. . . ] Hardware Top channel Window sash seal Qty. 3 1 1 1 1 2 Foam seal window lock bracket side curtains 2 Safety Lock (for Vinyl-Clad window) weather seals 1 Installation Instructions NOTE: available from your dealer or service center. See "Accessories. " Do not use any screws other than those specified here. Location Requirements: IMPORTANT:Observe all governing codes and ordinances. Check the location where air conditioner will be installed. Proper installation is your responsibility. [. . . ] A large enough opening for the air conditioner. Adequate wall support for weight of air conditioner. Air conditioner weights between 70 and 85 Ibs (32 to 40 kgs). NOTE: Do not use an extension cord. Air must be able to pass freely through the cabinet louvers. (FIG. 1) Window Installation: Window opening measurements (FIG. 2) : FIG. 1 A FIG. 2 A. Cabinet louvers Remove packaging material: Remove and dispose of / recycle packaging materials. Remove tape and glue residue from surfaces before installing the air conditioner. Rub a small amount of liquid dish soap over the adhesive with your fingers. Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue. These products can damage the surface of your air conditioner. 1 Remove the air conditioner from the carton and place it on cardboard. Remove 1 shipping screw from each side of the cabinet (FIG. 3A). Drill holes and drive locking screws: A: For wooden windows: screws through the holes in the side curtains into the window C B: For Vinyl-Clad windows: screw screw 3. Trim the weather seal 4 Installation Instructions FIG. 15 Complete Installation: 1. Insert window sash seal behind the top of the lower window sash and against the glass of the upper window (FIG. 15). Place the window-lock bracket on top of lower window and against upper window sash on right side of the window (FIG. 15). round-head screws to secure window in place (FIG. 15). Insert air conditioner into cabinet (FIG. 16). Insert front tabs of front panel into top of cabinet and swing front into place (FIG. 17A). Attach bottom front of panel with front panel screws (FIG. 17B). FIG. 16 FIG. 17A FIG. 17B B C A D A. Window sash seal screws electronics plug Through-the-Wall Cabinet Installation: Option 1--wood, metal or plastic molding: When using a wood, metal or plastic molding, the wood frame should line up with the inside wall as shown FIG. 18. Option 2--Plastered wall with no molding: into the inside wall FIG. 19. FIG. 18 ABC AB FIG. 19 FIG. 20 C D D A B D C C. [. . . ] Apply the wood preservative to the outside exposed surface. Attach frame securely to the wall. 5 Installation Instructions FIG. 21 A NOTE: Dimension for depth depends on wall thickness and type of molding (FIG. 21). Do not block louvers in air conditioner cabinet. Outside height B C Install Cabinet into Wood Frame: 2. [. . . ]