User manual FRIGIDAIRE FPRH19D7L

[. . . ] Use & Care of your All about the Refrigerator TA B L E O F C O N T E N T S Important Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Features at a Glance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Door Handle Removal Instructions . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Unpackage the new filter and place it inside the hinged bottom cover of the housing. Push the hinged bottom cover upward until the tab snaps into closed position. Air Filter Open Air Filter Cover Remove Air Filter INTERIOR LIGHTING The mid level and upper level lighting comes on automatically when the door is opened. To replace the light bulbs: IMPORTANT To disconnect power to the unit, unplug the unit or switch the breaker that supplies power to the unit to the off position. Replace the old bulb with a bulb of the same wattage. To replace the light bulb, turn the temperature control to OFF and unplug the electrical cord. Remove the lens from the lamp housing by unsnapping it from the lamp housing using your fingers or a screwdriver. Be careful not to break the locking tabs on the lamp housing. Replace the old bulb with a bulb of the same type and wattage. To replace the lens, snap one side of the lens opening to the tab on the lamp housing. Then carefully attach the other side. Mid Level Lighting Light Bulb Removal 12 STORAGE FEATURES Upper Level Lighting The upper level lighting comes on automatically when the door is opened. To replace the light bulbs: IMPORTANT To disconnect power to the unit, unplug the unit or switch the breaker that supplies power to the unit to the off position. Replace the old bulb with a bulb of the same wattage. To replace the light bulb, turn the temperature control to OFF and unplug the electrical cord. Remove the light shield by pushing in on the sides where the two tabs are located in the back, then rotate the light shield down and out. Replace the old bulb with a bulb of the same type and wattage. When replacing the light shield, insert the three tabs in the front of the light shield into the slots in the control box and then rotate the rear upward until the two retaining latches lock into place. Light Shield Light Shield Tabs STORAGE SpaceWiseTM Glass Shelves Multi-position adjustable slide out glass shelves can be moved to any position for larger or smaller packages. The shipping spacers that stabilize the shelves for shipping may be removed and discarded. Insert Into Slots To Adjust The Shelves · · · Lift front edge up. Replace the shelf by inserting the hooks at rear of the shelf into the wall bracket. Lower the shelf into the desired slots and lock into position. rawe Deli D r r Cove Deli Drawer This model is equipped with a Deli Drawer for storage of luncheon meats, spreads, cheeses, and other deli items. 13 STORAGE FEATURES Crisper Drawer With Adjustable Dividers The crisper drawer, located at the bottom of the refrigerator interior, is designed for storing fruits, vegetables, and other fresh produce. Wash items in clean water and then remove excess water before placing them in the crisper. Items with strong odors or high moisture content should be wrapped before storing. Dividers may be adjusted for different size items within the crisper. To remove the Crisper Drawer or Deli Drawer: 1. Remove the glass cover from the drawer to be removed. [. . . ] When the surrounding noise level is low, you might hear the compressor running while it cools the interior. * This is normal. Sound will level off or disappear as refrigerator continues to run. Popping or cracking * sound when compressor comes on. Vibrating or rattling noise. Metal parts undergo expansion and * This is normal. Sound will level off or disappear as refrigerator contraction, as in hot water pipes. [. . . ]