User manual FRIGIDAIRE GLVC25V7DB1

[. . . ] Do Not Use To Exhaust Hazardous Or Explosive Materials And Vapors. WARNING ­ TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: a. Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer. Before servicing or cleaning unit, switch power off at service panel and lock the service disconnecting means to prevent power from being switched on accidentally. [. . . ] b) Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel burning equipment to prevent back drafting. Follow the heating equipment manufacturer's guideline and safety standards such as those published by the National Fire Protection Association (NFPA), and the American Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE), and the local code authorities. c) When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities. d) Ducted fans must always be vented to the outdoors. WARNING - TO REDUCE THE RISK OF FIRE, USE ONLY METAL DUCTWORK. WARNING Electrical Shock Hazard - Can result in serious injury or death. Disconnect appliance from electric power before servicing. If equipped, the fluorescent light bulb contains small amounts of mercury which must be recycled or disposed of according to Local, State, and Federal Codes. 3 Installation FOR RESIDENTIAL USE ONLY NOT TO BE INSTALLED OVER GAS GRILLS PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING. INSTALLATION MUST COMPLY WITH ALL LOCAL CODES. IMPORTANT: Save these Instructions for the Local Electrical Inspector's use. INSTALLER: Please leave these Instructions with this unit for the owner. OWNER: Please retain these instructions for future reference. For alignment, adjust the back stops of the box. For box adjustment, loosen screws M , slide the square plates P as necessary, and tighten screws M (Figure 7). Ensure that the drawer, when fully retracted, turns OFF all power by acting positively on the rear microswitch. ELECTRICAL GROUNDING INSTRUCTIONS THIS APPLIANCE IS FITTED WITH AN ELECTRICAL JUNCTION BOX WITH 3 WIRES, ONE OF WHICH (GREEN/YELLOW) SERVES TO GROUND THE APPLIANCE. TO PROTECT YOU AGAINST ELECTRIC SHOCK, THE GREEN AND YELLOW WIRE MUST BE CONNECTED TO THE GROUNDING WIRE IN YOUR HOME ELECTRICAL SYSTEM, AND IT MUST UNDER NO CIRCUMSTANCES BE CUT OR REMOVED. Warning: Turn off power circuit at the service panel before wiring this unit. Remove j-box cover as shown in Figure 8. Remove the knockout and install the strain relief (conduit) connector (1/ 2") in junction box. Run 3 wires; black, white and green (#16 AWG) in 1/2" conduit from service panel to junction box. Connect black wire from service panel to black or red in junction box, white to white and green to green-yellow. Close junction box cover, check all light bulbs to make sure they are secure in their sockets, then turn power on in service panel and check lights and blower operation per Care & Use section of this manual and install filters. [. . . ] If new lights do not operate be sure lights are inserted correctly before calling service. · Remove the light shield Q by pushing simultaneously the two unlocking buttons R (Figure 12); for safety reasons make sure to remove the light shield from its suspension slides G . · Pull out fluorescent tube and replace with Philips Type PL-S 9 Watt maximum. Figure 12 8 9 RANGE HOOD WARRANTY Your range hood is protected by this warranty In the U. S. A. , your appliance is warranted by Electrolux Home Products North America, a division of White Consolidated Industries, Inc. [. . . ]