User manual FRIGIDAIRE R1520

[. . . ] INSTRUCTION BOOK REFRIGERATOR R 1520 (TT 160**) (200**) (250**) 1278823 A/F/23. (00. ) Before installing and using the appliance read this user's instruction book carefully. It contains safety precautions, hints, information and ideas. If the refrigerator is used in compliance with the instructions written, it will operate properly and provide you with greatest satisfaction. [. . . ] Be sure that the condenser and the compressor are well ventilated. Do not cover the sections where ventilation is. Wrap products in tightly closing dishes or cling film to avoid building up unnecessary frost. 8 We recommend to defrost the frozen food compartment once a week and when the frost is more than 4-5 mm. Put the drip tray into closed position, then push the defrosting button in the center of the knob of the thermostatic control at the right side of the fresh food compartment. During defrosing cooling is interrupted after finishing it starts again automatically. Defrosting usually takes several hours, at the end you can remove the collected water from the drip tray by placing another tray under it then pull out the plastic cork at the bottom. When the thaw water came out, replace the cork. Regular cleaning It is recommended to wash the inside of the refrigerator in 3-4 weeks time. Household cleaner or soap must not be used. After you made it no-current wash the appliance using lukewarm water and wipe it. Clean the magnet door rubber profile with clean water. After cleaning plug the appliance to the mains socket. It is practical to clean and defrost the frozen food compartment at a time and when it is empty. Dust and dirt collected on the back of the refrigerator, condenser is recommended to be removed once or twice a year. When the refrigerator is not in use Break the circuit of the appliance. Defrost and clean it as written before. In case the appliance will not be used for a long time follow these steps: Leave the door open to avoid a build up of air inside. Trouble shooting How to change the bulb Should the light fail to work you can change it as below: Break the circuit of the appliance. Unscrew the plate screw fixing the lamp cover, then take the lamp cover off in the direction of arrow and the bulb can be changed. (Type of the bulb: Mignon 322, 230 V, 15 W, E 14 thread) After changing bulb replace the lamp cover, screw the plate screw and apply voltage to the appliance. The lack of light does not influence operation of the refrigerator. 9 If something does not work During operation of the appliance some smaller but annoying trouble can often occur, which does not require calling a technician out. In the following chart information is given about them to avoid unnecessary charges on service. We draw your attention that operation of appliance goes with certain sounds (compressor- and circulating Problem The appliance does not cool sufficiently sound). This is not trouble, but means normal operation. [. . . ] Fix the plate on the other side leaving the position of the door unchanged. Then screw in the one screw in the place set free on the other side as well as the adjustable feet (2 pieces) and set up the box. For refitting the upper door holder take out the screws (2 pieces) fixing the plastic top on the back of the box. Push back the top and lift it from the fixing elements. 12 Unscrew the screws fixing the upper door holder (2 pieces). [. . . ]