User manual FRIGIDAIRE RL2352

[. . . ] The appliance should be left for 2 hours after installation before it is turned on, in order to allow the refrigerant to settle. · · · · · · · · · Frozen food must NOT be re-frozen once it has thawed out. Do not place carbonated or fizzy drinks in the freezer. Do not remove items from the freezer if your hands are damp/wet, as this could cause skin abrasions or frost/freezer burns. Ice lollies can cause `frost/freezer burns' if consumed straight from the freezer. [. . . ] Connect the blue (neutral) wire to the terminal in the plug which is marked with the letter «N» or coloured black. Connect the brown (live) wire to the terminal in the plug which is marked with the letter «L» or coloured red. The plug moulded onto the lead incorporates a fuse. For replacement, use a 13amp BSI362 fuse. Only ASTA or BSI approved fuses should be used. The plug must not be used if the fuse cover/carrier is lost. The cover/carrier is indicated by the coloured insert at the base of the plug. A replacement cover/carrier must be obtained from your local Service Force Centre. 87/308 of 2. 6. 87 relative to radio interference suppression. This appliance complies with the following E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. E D PR60 Electrical connections Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. WARNING: THIS APPLIANCE MUST BE EARTHED. The manufacturer declines any liability should this safety measure not be observed. If the plug that is fitted to your appliance is not suitable for your socket outlet, it must be cut off and the appropriate plug fitted. The cut off plug should then be disposed of to prevent the hazard of shocks in case it should be plugged into a 13amp socket in another part of your home. Important The wires in the mains lead are coloured in accordance with the following code: Green and Yellow - Earth Blue - Neutral Brown - Live OPERATION Before using Remove all securing tapes. Wash inside the appliance with lukewarm water and bicarbonate of soda (5 ml to 0. 5 litre of water). Do not use soap or detergent as the smell may linger. The thermostat setting can vary as the temperature inside the refrigeration compartment depends on the following factors: ­ room temperature ­ how often the door is opened ­ how much food is stored ­ position of the appliance Important During prolonged periods of abnormally hot weather, if the thermostat is set on too high a number, the cooling system may operate continuously and the fridge cooling plate may not defrost. Turning the knob to a lower number will cause the automatic defrosting to resume. Setting the temperature The temperature inside the refrigerator is regulated by a thermostat with 6 temperature positions and an "OFF" (O) position. Position 1 = minimum coldness Position 6 = maximum coldness Turn the thermostat dial to the required position. The intermediate position is usually the most suitable (3-4). 4 13 AMP BROWN 9 TECHNICAL SPECIFICATIONS DIMENSIONS Height Width Depth 124 55 60 cm cm cm Fresh food refrigeration To obtain the best performance, do not store warm food or evaporating liquids in the refrigerator; do cover or wrap the food, particularly if it has a strong flavour. [. . . ] Check that air ventilation is not obstructed. (see Maintenance and Cleaning). The temperature in the fridge External cleaning Wash the outer cabinet with warm soapy water. An accumulation of dust will affect the performance of the appliance and cause excessive electricity consumption. Once or twice a year dust the condenser (black grill) and the compressor at the back of the appliance, with a brush or vacuum cleaner, see figure. D411 The compressor runs continously Defrosting The refrigerator automatically defrosts every time the compressor stops. [. . . ]