User manual FRIGIDAIRE TD920

[. . . ] Carefully unpack air conditioner 115V 15A 230V 15A 230V 20A window support brackets) 230V 30A Do not, under any circumstances, cut, remove or bypass the grounding prong. HEAVY DUTY (22, 000~28, 500BTU) FIG. 3 Tools Required tape measure adjustable wrench or pliers pencil Socket wrenches 7 1 and locknut 10 4 ea weather seals panhead and Locknut foam insert 2 Installation Instructions Window 1 Mounting Remove Air Conditioner from Cabinet NOTE: Remove any packaging material from cabinet exterior. 1. Pull down on front grille from upper edge. Lift front grille upwards and place to one side. To remove, grasp in the middle on each side. [. . . ] With the aid of an assistant, hold the cabinet while pulling on the base pan handle (see FIG. 4), and carefully remove the air conditioner from cabinet. Add two foam inserts to holes in top of cabinet where shipping screws were removed from. Except 22, 000BTU model, other heavy duty models (24, 000~28, 500BTU) come with internal shipping packaging. THIS PACKAGING AND PLASTIC TIES MUST BE REMOVED PRIOR TO INSTALLING THE AIR CONDITIONER BACK INTO THE CABINET. Remove plastic wrapping from all points on power cord. FIG. 7 FIG. 5 shipping Shipping Packaging screws FIG. 6 Plastic tie 2 Install Top Angle Rail and Side Retainers 1. Remove adhesive strip coating from foam gasket. Attach adhesive side of gasket to bottom of top angle rail. Insert 4 screws from inside of cabinet and secure to top angle rail. From inside of cabinet insert 3 screws to attach each side retainer as shown in Fig. Position vent control lever so that it will thread into its channel in the front panel (see FIG. 21). Hook front panel top tabs into slots on cabinet top, and rotate front panel down so that side tabs snap into place on cabinet. Insert 4 previously removed screws through front panel and into air conditioner. Reinstall the front grille by hooking bottom tabs into slots on Front Panel bottom, then rotating grille up to snap into place. 5 Installation Instructions Thru-The-Wall Installation NOTE: 1 Select Wall Location This air conditioner slides out from its cabinet, so that it can be installed through an outside wall as explained below. NOTE: IMPORTANT: Side louvers must never be blocked. All parts needed for Thru-The-Wall Installation are provided, except a wood frame, shims, and 10 wood screws 2 Prepare Wall 22, 000~28, 500BTU 15, 000~18, 500BTU FIG. 1 FIG. 2 Y Inside Inside Width X 6 Installation Instructions 4. Build a wooden frame with the INSIDE dimensions of your model listed above. (Measure twice remember. . . ) Frame depth should be the same as wall thickness. Fill in the space from the opending to the studs with wood spacers, as shown. Nail frame to spacers to spacers with front flush with dry wall. NOTE: If wall thickness is 8-1/2" or more, add alumimum flashing over bottom of frame opening to assure no water can enter area between inner and outer wall. NAIL SPACERS TO STUDS FIG. 3 FIG. 4 CAULK AS REQUIRED LEVEL ALUMINUM FLASHING OVER BOTTOM OF FRAME 3 Prepare and Install Cabinet 1. Slide air conditioner from cabinet; refer back to Step 1 of Window Mounting. Place cabinet into opening with bottom rail resting firmly on bottom board of wooden frame. [. . . ] Install air conditioner into cabinet by following all steps in Step 9 of Window Mounting. OPTIONAL: Caulking and installation of trim on interior wall may be done. You can buy wood from your local lumber or hardware supply. On the outside, caulk opendings around top and sides of cabinet, and all sides of wood sleeve to the opening. NOTE: See Step 5, Item 4 of Window Mounting Instructions for bottom rail seal location. [. . . ]