User manual FUJIFILM FINEPIX Z2

[. . . ] 1 2 3 4 5 6 OWNER'S MANUAL This manual will show you how to use your FUJIFILM DIGITAL CAMERA FinePix Z2 correctly. Please follow the instructions carefully. Getting Ready Using the Camera Advanced Features Settings Software Installation Viewing Images BL00499-200 (1) WARNINGS To reduce the risk of fire or electric shock, do not expose the AC power adapter to rain or moisture. The AC power adapter should not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, should be placed on the AC power adapter. Warning To prevent fire or shock hazard, do not expose the unit to rain or moisture. For customers in the U. S. A. Tested To Comply With FCC Standards FOR HOME OR OFFICE USE IMPORTANT SAFETY INSTRUCTIONS hRead these instructions. hDo not block any ventilation openings, Install in accordance with the manufacturer's instructions. [. . . ] h Optical zoom focal length (35 mm camera equivalent) Approx. 60 cm (2. 0 ft. ) to infinity 3 Advanced Features Images that can be trimmed You cannot trim images that were shot with a camera other than FinePix Z2. 70 Continued 71 MOVIE MODE r RECORDING MOVIES Press the shutter button down fully to start recording. p PHOTO MODE MOVIE QUALITY SETTINGS IN MOVIE MODE 2 0 1 Set the Mode switch to "r". 2 Press the "p" button to display the menu on the LCD monitor. 4 1 10 ! The brightness and color of the LCD monitor shown during movie recording may differ from those shown before recording begins. There is no need to hold down the shutter button. Camera operation noises may be recorded during movie shooting. ! In "r" Movie mode, do not set the "" (sensitivity) setting. In "r" Movie mode, do not set the "" FinePix COLOR setting. The quality setting is retained even when the camera is off or the mode setting is changed. Pressing the shutter button down fully fixes the focus, however the exposure and white balance are adjusted to the scene being shot. 2 QUALITY : Press "c". 5 REC 7s During recording, "yREC" appears on the LCD monitor and a counter that shows the remaining time appears in the top-right corner of the LCD monitor. ! If the brig htness of the subject changes during movie recording, the sound of lens operation may be recorded. Some wind noise may be recorded in shots taken outdoors. When the remaining time runs out, recording ends and the movie is saved onto the xD-Picture Card. PHOTO MODE 6 Press the shutter button down halfway during recording, the recording ends. 1 30 2 0 1 Press "a" or "b" to change the setting. 2 Press the "MENU/OK" button to confirm the setting. 3 Advanced Features ! If recording is stopped immediately after it begins, 1 second of the movie is recorded onto the xD-Picture Card. 640x480: : 13s Available recording times Recording times per xD-Picture Card These figures are the available recording times using a new xD-Picture Card formatted on the camera. The actual recording times will vary depending on the free space available on the xD-Picture Card. PHOTO MODE Quality % (30 frames per second) DPC-16 (16 MB) DPC-32 (32 MB) DPC-64 (64 MB) DPC-128 (128 MB) DPC-256 (256 MB) DPC-512/M512 (512 MB) DPC-M1GB (1 GB) 13 sec. 14. 9 min. $ (30 frames per second) 26 sec. 29. 3 min. Quality settings in Movie mode Quality mode Sample uses For better quality To record longer movies % (640 480) $ (320 240) 72 73 PLAYBACK MODE PLAYING BACK MOVIES 2 0 1 Press the "w" button to turn the camera on in Playback mode. 2 Press "d" or "c" to select the movie file. 1 10 Adjusting volume of movies Volume can be adjusted while playing back movies. Adjust the volume to suit your condition. 1 ! Movies PLAY cannot be played back using multi-frame playback. Press the "DISP/BACK" button to select single-frame playback. Press the "MENU/OK" button while playing back movie. The movie is paused during playback. 0123456 7 8 9 10 Indicated by the "r" icon. 1 20 1 Press "b" to play the movie. 2 The playback time appears on the LCD monitor along with a progress bar. SET CANCEL 2 0 Bar 6s 2 ! [. . . ] When an xD-Picture Card is removed, the card could come out of the slot too quickly. Use your finger to hold it and gently release the card. Request regular internal testing and cleaning for your camera. Build-up of dust in your camera can cause a fire or electric shock. [. . . ]