User manual FUJIFILM FLASH TTL EF-20

[. . . ] For Your Safety Be sure to read these notes before use Safety Notes Thank you for your purchase of this product. For repair, inspection, or internal testing, contact your FUJIFILM dealer. · Make sure that you use your flash correctly. Read these safety notes and your Owner's Manual carefully before use. [. . . ] · Do not use batteries that are leaking, deformed, discolored, or with other abnormal states. · Do not mix old and new batteries, batteries with different charge levels, or batteries of different types. · If the flash will not be used for an extended period, remove the batteries. Note that various settings of the flash will be reset. · The batteries may be warm to the touch immediately after use. Turn the flash off and allow the batteries to cool before handling. · Battery capacity tends to decrease at low temperatures below 10°C (50°F). Keep spare batteries in a pocket or other warm place and exchange as necessary. Cold batteries may recover some of their charge when warmed. · Fingerprints and other stains on the battery terminals can affect a number of flash firing. Thoroughly clean the terminals with a soft, dry cloth before inserting batteries in the flash. CAUTION Do not place heavy objects on the flash. This can cause the heavy object to tip over or fall and cause injury. Do not cover or wrap the flash or the charger in a cloth or blanket. This can cause heat to build up and distort the casing or cause a fire. 11 DE EN JA Rechargeable AA Ni-MH Batteries The capacity of Ni-MH batteries may be temporarily reduced when new, after long periods of disuse, or if they are repeatedly recharged before being fully discharged. This is normal and does not indicate a malfunction. The flash draws a small amount of current even when off . Ni-MH batteries that have been left in the flash for an extended period may be drawn down to the point that they no longer hold a charge. Batteries that no longer hold a charge even after repeatedly being discharged and recharged have reached the end of their service life and must be replaced. Ni-MH batteries can be recharged in a battery charger (sold separately). Batteries may become warm to the touch after charging. Refer to the instructions provided with the charger for more information. Use the charger with compatible batteries only. [. . . ] First, shoot a picture in standard auto mode (when the EV adjustment indicator is lit) and check it on the monitor. If you find that the brightness is too high or low, press the EV ADJUST button to fine adjust the brightness and take another picture. If the picture is darker than expected, press the EV ADJUST button once to increase the EV by one step so that the red "+0. 5" EV adjustment indicator lights up. In this condition, the unit emits light by increasing the brightness by +0. 5 EV. [. . . ]