User manual FUJIFILM INSTAX SQUARE SQ6

[. . . ] 34 Taking Pictures without Using the Flash (Flash Suppressing). € After reading this User’s Guide, keep it in a safe, easy to find place where you can refer to it if needed. 25 Part Names Front 2 1 EN 3 12 4 5 6 7 8 11 1 2 3 4 5 6 7 8 9 10 9 10 Power switch Film ejection slot Self timer lamp Viewfinder Strap hook Shutter button AE light sensor window Flash sensor window Tripod socket (Tripod sold separately) Lens/Lens cover Self-portrait mirror Flash lampface 11 12 26 Part Names (Continued) Rear 13 13 14 23 22 15 16 17 Mode indicator/LED Strap hook MODE (mode) button Self timer button Flash suppressing button Back cover lock Back cover Film counter Battery lid Film pack confirmation window Eyepiece EN 14 15 16 17 18 19 20 21 22 23 21 18 19 20 27 Attaching the Strap Attach the provided camera strap to the strap hook on each side as in the illustrations below. ~ EN Ÿ Caution • For safety, use the strap only as a shoulder strap. [. . . ] 5, Exposure compensation: ±2/3 EV Automatic Approximately 90 seconds (Varies depending on the ambient temperature) In Macro mode: Built-in, automatic electronic flash In a mode other than Macro mode: Always flashing Charging time: 0. 10 second delay, Can be stopped mid-run Shooting mode (Auto, Selfie, Macro, Landscape, Double exposure), Brightness adjustment, Flash suppressing, Self timer Mode Two CR2/DL CR2 lithium batteries Capacity: Approximately 30 instax SQUARE 10-pack film packs with new CR2/DL CR2 lithium batteries Film pack confirmation window, tripod socket (tripod sold separately) 118. (without battery, strap, and film pack) Two CR2/DL CR2 lithium batteries, Shoulder strap, Three flash filters EN Shutter Release Exposure Control Film Feeding Out Film Developing Time Flash Self-Timer LED Display Power Supply Others Dimensions & Weight Accessories * Specifications are subject to change for improvement. * Certification marks acquired by the camera are located on the back of the back cover. 38 TROUBLE SHOOTING ★When to replace the batteries 1 When the lens does not work when the power is switched on. 2 When it takes an unusually long amount of time for the flash to be charged. 3 When pressing the shutter button turns off the camera. * Replace both CR2 batteries with new lithium batteries of the same brand/type. tROUBLE SHOOTING During operation Problems The shutter release won’t trip. Possible Causes Solutions EN 1 Replace both batteries with new batteries. Please wait until the LED or the self timer lamp is flashing rapidly. 3 Unload the film pack, and load a new film pack. 1 Remove the batteries and reinsert them with the LED flashing. 2 If 1 does not resolve the problem, contact a FUJIFILM authorized distributor. 1 Use FUJIFILM Instant Film “instax SQUARE” only. ) 2 Match the yellow line on the film pack with the yellow positioning mark in your camera. follow the FUJIFILM Instant Film “instax SQUARE” instructions. — Replace both batteries with new batteries and load the film pack again. The LED(s) on the mode indicator is flashing. The film pack won’t load into your camera, or won’t load into your camera smoothly. 2 You are not loading the film pack correctly. Possible Causes 1 The camera shakes or has been dropped and the film is misaligned. [. . . ] Also, do not carry the camera while it is mounted to the tripod. personal injury or camera damage may result. 4 If you are not using your camera for a long interval, unload the batteries and keep it where it will be safe from heat, dust, and moisture. CAMERA CARE 44 5 Remove soil and dust from the lens, viewfinder window, etc. [. . . ]