User manual FUJITSU SIEMENS SCENIC P300 (I865G)

[. . . ] PS/2 and OS/2 Warp are registered trademarks of International Business Machines, Inc. All other trademarks referenced are trademarks or registered trademarks of their respective owners, whose protected rights are acknowledged. Copyright ã Fujitsu Siemens Computers GmbH 2002 All rights, including rights of translation, reproduction by printing, copying or similar methods, in part or in whole, are reserved. All rights, including rights created by patent grant or registration of a utility model or design, are reserved. [. . . ] How to dismantle and reassemble the device is described in the Operating Manual accompanying the device. Please observe the safety information provided in the "Important notes" chapter in the device's operating manual. Incorrect replacement of the lithium battery may lead to a risk of explosion. It is therefore essential to observe the instructions in the "Add-on modules" - "Replacing the lithium battery" section. A26361-D1387-Z120-1-7419 English - 1 Important notes The shipped version of this board complies with the requirements of the EEC directive 89/336/EEC "Electromagnetic compatibility". Compliance was tested in a typical PC configuration. When installing the board, refer to the specific installation information in the Operating Manual or Technical Manual for the receiving device. Connecting cables for peripherals must be adequately shielded to avoid interference. ! i Components can become very hot during operation. Ensure you do not touch components when making extensions to the system board. The warranty is invalidated if the device is damaged during the installation or replacement of system expansions. Information on which system expansions you can use is available from your sales outlet or the customer service centre. Information about boards To prevent damage to the system board or the components and conductors on it, please take great care when you insert or remove boards. Take great care to ensure that extension boards are slotted in straight, without damaging components or conductors on the system board, or any other components, for example EMI spring contacts. Cover monitoring protects the system from unauthorised opening. An onboard controller developed by Fujitsu Siemens Computers controls the temperature and system monitoring. The following functions are supported: Temperature monitoring: Measurement of the processor and the system temperature with an onboard temperature sensor. Temperature control: The temperature is controlled by adjusting the fan speed and/or by reducing the clock frequency of the processor. The clock frequency of the processor is dependent upon the setting in the BIOS Setup. Temperature-dependent processor speed control enables a reduced fan speed, decreasing noise. Fan monitoring: Fans which have been removed, blocked or sticky fans are detected. Blocked or sticky fans are operated with 12 V pulse voltage. If the device has a monitored fan removed while the system is switched off this is indicated by the message LED when the system is switched on again and processed by the BIOS or the application. Basic AOL II can also inform the administrator about hardware faults and software errors. The LAN RJ45 connector is equipped with a yellow and a green LED (light emitting diode). 2 1 2 1 a connection exists (e. g. [. . . ] Buffered memory modules are not supported. DDR-DIMM memory modules must meet the PC2100 specification. Installing a memory module 2 2 Ê Ê Ê Push the holders on each side of the memory compartment outwards. Insert the memory module into the location (1). At the same time flip the lateral holders upwards until the memory module snaps in place (2). Removing a memory module 1 1 Ê Ê Push the clips on the right and left of the compartment outward (1). [. . . ]