User manual FUJITSU SIEMENS SCENIC P320 (I865G)

[. . . ] any technical problems or other questions you need clarified?Please contact: · your sales partner · your sales outlet You will find further information in the manual "Safety, Guarantee and Ergonomics". The latest information on our products, tips, updates, etc. , can be found on the Internet under: http://www. fujitsu-siemens. com Dieses Handbuch wurde auf Recycling-Papier gedruckt. This manual has been printed on recycled paper. [. . . ] Please note the information provided in the chapter "Safety" in the Operating Manual of the device. Incorrect replacement of the lithium battery may lead to a risk of explosion. It is therefore essential to observe the instructions in the chapter , , Add-on modules" - , , Replacing the lithium battery". ! A26361-D1184-Z120-3-7419 English - 1 Important notes The shipped version of this board complies with the requirements of the EEC directive 89/336/EEC "Electromagnetic compatibility". Compliance was tested in a typical PC configuration. When installing the board, refer to the specific installation information in the Operating Manual or Technical Manual of the receiving device. Connecting cables for peripherals must be adequately insulated to avoid interference. ! i Components can become very hot during operation. Make sure you do not touch components when making extensions to the system board. The warranty is invalidated if the device is damaged during the installation or replacement of system expansions. Information on which system expansions you can use is available from your sales outlet or the customer service center. Information on boards To prevent damage to the system board or the components and conductors on it, please take great care when you insert or remove boards. Take care above all to ensure that extension boards are slotted in straight without damaging components or conductors on the system board, or any other components, for example EMI spring contacts. Be especially careful with the locking mechanisms (catches, centering pins etc. ) when you replace the system board or components on it, for example memory modules or processors. for the processor) 13 = Power supply monitoring 14 = Cover monitoring The components and connectors marked are not necessarily present on the system board. 6 - English A26361-D1184-Z120-3-7419 AMR Features Temperature monitoring / system monitoring One goal of temperature and system monitoring is to reliably protect the computer hardware against damage caused by overheating. In addition, any unnecessary noise is also to be prevented with a reduced fan speed, and information is to be provided on the system state. The cover monitoring protects the system from unauthorized opening. This LAN controller supports the transfer speeds 10 Mbit/s and 100 Mbit/s. The LAN controller is equipped with a 3 Kbyte transmission and receiving buffer (FIFO) and supports the WOL function through Magic Packetä. It is also possible to boot a device without its own boot hard disk via LAN. Here Bootix LAN BootP and Intel PXE are supported. The LAN RJ45 connector is equipped with a yellow and a green LED (light emitting diode). 1 = Yellow indicator 2 = Green indicator 1 2 Green Yellow a connection exists (e. Link Mode: WOL mode: the LAN connection is active. a Magic PacketTM is being received. 8 - English A26361-D1184-Z120-3-7419 Features Possible screen resolution Depending on the operating system used the screen resolutions in the following table refer to the screen controller on the system board. [. . . ] If PC133 memory modules are used it is only allowed to apply 3 single sided or 2 double sided memory modules. Installing memory modules ! 2 2 Ê Ê Ê Flip the holders on each side of the relevant location outwards. Insert the memory module into the location (1). At the same time flip the lateral holders upwards until the memory module snaps in place (2). Removing a memory module 1 1 Ê Ê Flip the holders to the right and left of the location outwards (1). [. . . ]