User manual FUJITSU SIEMENS SCENIC PRO D7/M7

[. . . ] Please send us your comments quoting the order number of the manual. Siemens AG User Documentation Department, The addresses of your service partners ICP CS BS2 OS ID4 are contained in the guarantee booklet Otto-Hahn-Ring 6 or in the service address booklet. D-81730 München The latest information on our products, tips, updates, etc. , can be found on the Internet under: http://www. siemens. com/pc Your training needs? The Siemens Training Centers offer you a wide range of training courses in information technology and on IT products and other subjects - onsite near to your workplace or offsite at one of our training centers. Let us know your training requirements or request information from us the fastest way is via fax under: +49 89 636-42945 Or write to: Siemens AG Training Center, Beratungsservice D-81730 München System board D969 Dieses Handbuch wurde auf Recycling-Papier gedruckt. This manual has been printed on recycled paper. [. . . ] Enabled Disabled The feature connector is enabled. The feature connector is disabled (default entry). 30 A26361-D969-Z120-8-7619 Advanced - Advanced system configuration Settings in BIOS Setup Plug & Play O/S defines the Plug&Play functionality. Plug&Play means that inserted modules are automatically recognized and installed if they support Plug&Play. Yes The operating system takes over some of the Plug&Play functions. You should select this setting only if the operating system supports Plug&Play. The BIOS takes over the complete Plug&Play functionality (default setting). No Reset Configuration Data This field specifies whether the configuration data is reset and reinitialized when the PC is started. Yes When the PC is started the old configuration data is reset and the entry in this field is set to NO. The new configuration data is determined by means of the Plug&Play functionality. The mounted modules and drives are then initialized with this data. The Plug&Play functionality ascertains the current configuration data and uses it to initialize the installed modules and drives. There is no update when the system is started (default entry). No Large Disk Access Mode - Hard disk access specifies the type of hard disk access for large hard disks (more than 1024 cylinders, 16 heads). The setup message is not displayed. 34 A26361-D969-Z120-8-7619 Security menu - Setting up the security features Settings in BIOS Setup Virus Warning This field checks the boot sectors of the hard disk drive to see if any changes have been made since the previous system startup. If they have been changed and the reason for this is unknown, a program for finding computer viruses should be loaded. Enabled If the boot sector has been changed since the previous system startup (e. g. new operating system or virus attack), a warning is displayed. The warning stays on the screen until you acknowledge the changes with Confirm or deactivate the function (Disabled). This entry confirms a required change in a boot sector (e. g. The boot sectors are not checked (default entry). Confirm Disabled Diskette Write This field is used to enable and disable floppy disk write-protection. Enabled Disabled Floppy disks can be read, written or deleted, the write protection in BIOS setup must be disabled (switch 8 off, default entry). The diskettes can only be read. Flash Write This field can assign write protection to the System BIOS. Enabled Disabled The System BIOS can be written or deleted. BIOS update from floppy disk is possible (default entry). [. . . ] Fixed Disk 0 Failure Fixed Disk 1 Failure Fixed Disk Controller Failure Controleer in de setup van het BIOS, in het menu Main, de instellingen van de harde schijf. Controleer de aansluitingen en de jumpers van de harde schijf. Incorrect Drive A - run Setup Incorrect Drive B - run Setup Stel in de setup van het BIOS, in het menu Main, het diskettestation op de juiste wijze in. Invalid NVRAM media type Start de PC opnieuw. [. . . ]