User manual FUJITSU SIEMENS XPERT 52XX/53XX

[. . . ] Additional Technical Manual D990 Introduction This technical manual applies for the mainboard D990. This system board is available in different configuration levels. [. . . ] GND VCC MOUSE CLK n. c. Pin 2 Pin 1 USB Connector A / B Pin 1 2 3 4 Signal VCC DATA_NEGATIVE DATA_POSITIVE GND PIN 1 B PIN 1 A A26361-D990-Z180-2-7619 Revision 1. 0 Seite 5 / 11 Additional Technical Manual D990 2. 1. 16 Audio/Gameport-Connector Pin 1 2 3 4 5 6 7 8 2. 1. 17 Signal GAME_VCC JOY_PORT_L<0> XJOY_TIMER_A<0> GND GND XJOY_TIMER_A<1> JOY_PORT_L<1> GAME_VCC Pin 9 10 11 12 13 14 15 Signal GAME_VCC JOY_PORT_L<2> XJOY_TIMER_A<2> XMIDI_OUT_H XJOY_TIMER_A<3> JOY_PORT_L<2> XMIDI_EXT_IN_H Pin 1 Pin 9 Speaker / Line Input Microphone Line Output Input Internal CD-ROM Audio Connector Pin 1 2 3 4 2. 1. 18 Signal Left CD Audio Input GND GND Right CD Audio Input Pin 1 Internal MPEG Audio Connector Pin 1 2 3 4 2. 1. 19 Signal Pin 1 GND Left MPEG Audio Input GND Right MPEG Audio Input Internal Voice Modem Connector Pin 1 3 5 Signal Speaker Input from MODEM GND Microphone Output to MODEM Pin 2 4 6 Signal Pin 1 Pin 2 n. c. Key n. c. A26361-D990-Z180-2-7619 Revision 1. 0 Seite 6 / 11 Additional Technical Manual D990 2. 1. 20 Infrared Connector Pin 1 2 3 4 5 2. 1. 21 Signal Pin 1 VCC Key IRDA_RX GND IRDA_TX Feature Connector Pin 1 3 5 7 9 11 13 15 17 19 21 23 25 2. 1. 22 Signal GND GND GND Video Enable SYNC Enable DCLK Enable n. c. GND GND GND GND VIDRST Key Pin 2 4 6 8 10 12 14 16 18 20 22 24 26 Signal Video Data 0 Video Data 1 Video Data 2 Video Data 3 Video Data 4 Video Data 5 Video Data 6 Video Data 7 DCLK BLANK HSYNC VSYNC GND Pin 1 Pin 2 Configuration SWITCH-Block (DIP-Switch) for Frequency selection, Recovery and Password clear Function: SW1 SW2 SW3 SW4 SW5 SW6 SW7 SW8 Recover BIOS On Off Password Skip On Off Floppy Write Protect On Off On = 0 = Close x x x x x x x x x x x x x x On Off x x x x x x x x x x On Off x x x x x x x x x x x x On Off x x x x x x Off = 1 = Open x = don't care A26361-D990-Z180-2-7619 Revision 1. 0 Seite 7 / 11 Additional Technical Manual D990 Frequency-setting for Intel P54 Processor: 12345678 ON=0 1 12345678 90 100 12345678 BUS = 60 MHz BUS = 66 MHz BUS = 60 MHz BUS = 66 MHz BUS = 60 MHz BUS = 66 MHz BUS = 66 MHz Core = x 1, 5 Core = x 1, 5 Core = x 2, 0 Core = x 2, 0 Core = x 2, 5 Core = x 2, 5 Core = x 3, 0 ON=0 1 ON=0 1 12345678 120 133 12345678 ON=0 1 ON=0 1 12345678 150 166 12345678 ON=0 1 ON=0 1 200 Frequency-setting for Intel P55 (MMX) Processor: 12345678 ON=0 1 12345678 166 200 12345678 BUS = 66 MHz BUS = 66 MHz BUS = 66 MHz Core = x 2, 5 Core = x 3, 0 Core = x 3, 5 ON=0 1 ON=0 1 233 Frequency-setting for AMD (K6) Processor: 12345678 ON=0 1 12345678 166 200 12345678 BUS = 66 MHz BUS = 66 MHz BUS = 66 MHz Core = x 2, 5 Core = x 3, 0 Core = x 3, 5 ON=0 1 ON=0 1 233 Switchposition: ON (0) ON=0 1 switch or knob position OFF (1) ON=0 1 switch or Knob position 2. 1. 23 Processor supply-voltage setting Processor-type Intel AMD K6 - 166 AMD K6 - 200 AMD K6 - 233 Jumper Pin 1 1-2-3 1-2 2-3 2. 1. 24 PCI-SLOT Configuration And Placement PCI-SLOT PCI-SLOT 1 PCI-SLOT 2 PCI-SLOT 3 PCI-SLOT 4 IDSEL ADR 28 ADR 29 ADR 30 ADR 31 Device Number 11h 12h 13h 14h A26361-D990-Z180-2-7619 Revision 1. 0 Seite 8 / 11 Additional Technical Manual D990 2. 2 Power Requirements (Power Supply) Voltage + 5. 1 V -5V + 12 V - 12 V + 3. 4 V + 5. 0 V (aux) Max. Variation +/- 5 % +/- 5 % +/- 10 % +/- 10 % +/- 5 % Max. Current Tbd Tbd Tbd Tbd Tbd Tbd - - - - power: at least 145 W ATX-compliant Remote on/off support continous voltage supply with at least 5V/20mA 3 Installing drivers and utilities Insert the "Drivers & Utilities" CD. When the DeskStart window appears, select Explore the CD via HTML. Select the language in which you want to operate the user interface. Here you will find the required drivers and utilities. For the following components, install the software offered to you in the HTML interface: - - - - Audio board (sound card) "Crystal" Hard disk controller "PIIX4" Software update "DirectX 3. 0a" Monitor controller (graphics card) "Matrox Mystique" A26361-D990-Z180-2-7619 Revision 1. 0 Seite 9 / 11 Additional Technical Manual D990 4 4. 1 Upgrades Main Memory Further information is given in the main technical manual. Correct functionality of the mainboard D990 is only warranted with the usage of the following DIMMModules. Recommended memory modules: 16MB DIMM SDRAM 2Mx64 Producer SAMSUNG 32MB DIMM SDRAM 4Mx64 Producer NEC SAMSUNG SIEMENS HYUNDAI 64MB DIMM SDRAM 8Mx64 Producer NEC SAMSUNG 128MB DIMM SDRAM 16Mx64 Producer NEC SAMSUNG Part. -No MC-4516CD644F-A10 KMM366S1623AT-G2 Part. -No MC-458CB644F-A10 KMM366S823AT-G2 Part. -No MC-454AD644F-A67 KMM366S403BTN-G2 HYS64V4020GU-10 HYM7V64400TFG-10 Part. -No KMM366S203BTN-G2 A26361-D990-Z180-2-7619 Revision 1. 0 Seite 10 / 11 Additional Technical Manual D990 4. 2 VGA Memory Upgrade Further information are shown in the main technical manual. Use only the standard 2 MB VGA memory extension (up to 4 MB VGA memory) for the Matrox Mystique grapic cards. 4. 3 Wavetable-Upgrade The mainboard D990 is prepared for a single chip wavetable-upgrade with the Crystal CS9236. To order please ask your local dealer. 5 BIOS-Fax The mainboard D990-A1x supports the BIOS-fax functionality, developed by SIEMENS NIXDORF. This is a special feature for receiving faxes although the PC is in standby-mode. [. . . ] Die übrigen erwähnten Hard- und Softwarenamen sind Handelszeichen und/oder Warenzeichen der jeweiligen Hersteller. Liefermöglichkeiten und technische Änderungen vorbehalten. A26361-D990-Z180-2-7619 [. . . ]